KSY 16
Absolute Maximum Ratings
Parameter
Operating temperature
Storage temperature
Supply current
Thermal conductivity1)
Symbol
TA
Tstg
I1
GthC
Electrical Characteristics (TA = 25 °C)
Nominal supply current
Open-circuit sensitivity
Open-circuit Hall voltage
I = I1N, B = 0.1 T
Ohmic offset voltage
I = I1N, B = 0 T
Linearity of Hall voltage
B = 0…0.5 T
B = 0…1 T
Input resistance
B=0 T
Output resistance
B=0 T
Temperature coefficient of the
open-circuit Hall voltage
I1 = I1N, B = 0.1 T
Temperature coefficient of the internal
resistance
B=0 T
Change of offset voltage within the
temperature range2)
I1N
KB0
V20
VR20
FL
FL
R10
R20
TCV20
TCR10, R20
∆VR0
Limit Values
– 40…+ 150
– 50…+ 160
7
≥ 2.2
5
190…260
95…130
≤ ± 20
≤ ± 0.2
≤ ± 0.7
900…1200
900…1200
∼ – 0.03…– 0.07
∼ 0.1…0.18
≤2
Unit
°C
°C
mA
mW/K
mA
V/AT
mV
mV
%
%
Ω
Ω
%/K
%/K
mV
Connection of a Hall Sensor with a Power Source
Since the voltage on the component must not exceed 10 V, the connection to the
constant current supply should only be done via a short circuit by-pass. The by-pass
circuit-breaker shall not be opened before turning on the power source. This is to avoid
damage to the Hall sensor due to power peaks.
1) Thermal conductivity chip-ambient when mounted on alumina ceramic 15 mm × 17 mm × 0.7 mm
2) AQL: 0.65
Data Sheet
2
1999-04-01