ZL60102(2004) View Datasheet(PDF) - Zarlink Semiconductor Inc

Part Name

Description

Manufacturer

ZL60102
(Rev.:2004)

12 x 2.7 Gbps Parallel Fiber Optic Link Transmitter and Receiver

Zarlink Semiconductor Inc 

ZL60101/2

Data Sheet

ZL60102 Receiver Specifications

All parameters below require operating conditions according to Table 2 and a termination load of 100 Ω differential

at the electrical output.

Parameter

Symbol

Min.

Max.

Unit

Optical Parameters

Input optical power1

Center wavelength

Return loss2

Total jitter contributed (peak to peak)3

PIN

-16

-2

dBm

λC

830

860

nm

RL

12

dB

TJ

120

ps

Deterministic jitter contributed (peak to peak)

Stressed receiver sensitivity4

Channel to channel skew5

Signal detect assert

Signal detect de-assert

Electrical Parameters

DJ

50

ps

PSS

-11.3

dBm

tSK

100

ps

PSA

-17

dBm

PSD

-27

dBm

Power dissipation

PD

1.5

W

Supply current

Differential output voltage amplitude (peak to peak)6

Output differential load impedance7

Stressed receiver eye opening8

ICC

450

mA

∆VOUT

500

800

mVp-p

ZL

80

120

Ω

PSE

0.3

UI

Electrical output rise time (20 - 80 %)

tRE

150

ps

Electrical output fall time (20 - 80 %)

tFE

150

ps

1. Receive power for a channel is measured for a BER of 10-12 and worst case extinction ratio. PIN (Min) is measured using a fast

rise/fall time source with low RIN and adjacent channel(s) operating with incident power of 6 dB above PIN (Min).

2. Return loss is measured as defined in TIA/EIA-455-107A Determination of Component Reflectance or Link/System Return Loss Us-

ing a Loss Test Set.

3. Total jitter equals TP3 to TP4 as defined in IEEE 802.3 clauses 38.2 and 38.6 (Gigabit Ethernet).

4. The stressed receiver sensitivity is measured using PRBS 223-1 pattern, 2.7 dB inter-symbol interference, ISI (Min), 30 ps duty cycle

dependent deterministic jitter, DCD DJ (Min), and 7 dB extinction ratio, ER (Min) (ER penalty = 1.76 dB). All channels not under test

are receiving signals with an average input power of 6 dB above PIN (Min).

5. Channel skew is defined for the condition of equal amplitude, zero ps skew signals applied to the receiver inputs.

6. Differential output voltage is defined as the peak to peak value of the differential voltage between DOUT+ and DOUT- and measured

with a 100 Ω differential load connected between DOUT+ and DOUT-. Data outputs are CML compatible.

7. See Figure 14.

8. The stressed receiver eye opening represents the eye at TP4 as defined in IEEE 802.3 clauses 38.2 and 38.6 (Gigabit Ethernet).

The stressed receiver eye opening is measured using PRBS 223-1 pattern, 2.7 dB ISI min, 30 ps DCD DJ min, 7 dB ER min and an

average input power of -10.8 dBm (0.5 dB above minimum stressed receiver sensitivity as defined in IEEE 802.3 clause 38.6). All chan-

nels not under test are receiving signals with an average input power of 6 dB above PIN (Min).

10

Zarlink Semiconductor Inc.

Share Link: