GAL16V8B-20LJ View Datasheet(PDF) - Lattice Semiconductor
Part Name
Description
Manufacturer
GAL16V8B-20LJ Datasheet PDF : 23 Pages
| |||
SpSepceifcicifaictaiotinosnGs GALA1L61V68VC8
ABSOLUTE MAXIMUM RATINGS(1)
Supply voltage V ....................................... –0.5 to +7V
CC
Input voltage applied .......................... –2.5 to V +1.0V
CC
Off-state output voltage applied .......... –2.5 to V +1.0V
CC
Storage Temperature ................................. –65 to 150°C
Ambient Temperature with
Power Applied ........................................ –55 to 125°C
1.Stresses above those listed under the “Absolute Maximum
Ratings” may cause permanent damage to the device. These
are stress only ratings and functional operation of the device
at these or at any other conditions above those indicated in the
operational sections of this specification is not implied (while
programming, follow the programming specifications).
RECOMMENDED OPERATING COND.
Commercial Devices:
Ambient Temperature (TA) ............................... 0 to 75°C
Supply voltage (V )
CC
with Respect to Ground ..................... +4.75 to +5.25V
Industrial Devices:
Ambient Temperature (TA) ...........................–40 to 85°C
Supply voltage (VCC)
with Respect to Ground ..................... +4.50 to +5.50V
DC ELECTRICAL CHARACTERISTICS
Over Recommended Operating Conditions (Unless Otherwise Specified)
SYMBOL PARAMETER
CONDITION
MIN. TYP.3 MAX. UNITS
VIL
Input Low Voltage
VIH
Input High Voltage
IIL1
Input or I/O Low Leakage Current
0V ≤ VIN ≤ VIL (MAX.)
IIH
Input or I/O High Leakage Current
3.5V ≤ VIN ≤ VCC
VOL
Output Low Voltage
IOL = MAX. Vin = VIL or VIH
VOH Output High Voltage
IOH = MAX. Vin = VIL or VIH
IOL
Low Level Output Current
IOH
High Level Output Current
IOS2
Output Short Circuit Current
COMMERCIAL
VCC = 5V VOUT = 0.5V TA= 25°C
ICC
Operating Power VIL = 0.5V VIH = 3.0V
L -5/-7
Supply Current
ftoggle = 15MHz Outputs Open
INDUSTRIAL
ICC
Operating Power VIL = 0.5V VIH = 3.0V
L -7
Supply Current
ftoggle = 15MHz Outputs Open
Vss – 0.5 —
2.0
—
—
—
—
—
—
—
2.4
—
—
—
—
—
–30
—
0.8
V
Vcc+1 V
–100 µA
10
µA
0.5
V
—
V
16
mA
–3.2 mA
–150 mA
—
75
115
mA
—
75
130
mA
1) The leakage current is due to the internal pull-up resistor on all pins. See Input Buffer section for more information.
2) One output at a time for a maximum duration of one second. Vout = 0.5V was selected to avoid test problems caused by tester
ground degradation. Guaranteed but not 100% tested.
3) Typical values are at Vcc = 5V and TA = 25 °C
3-74
1996 Data Book
Share Link: 