RMPA29200 View Datasheet(PDF) - Fairchild Semiconductor
Part Name
Description
Manufacturer
RMPA29200 Datasheet PDF : 10 Pages
| |||
Application Information
CAUTION: THIS IS AN ESD SENSITIVE DEVICE.
Chip carrier material should be selected to have GaAs compatible thermal coefficient of expansion and high thermal
conductivity such as copper molybdenum or copper tungsten. The chip carrier should be machined, finished flat, plated with
gold over nickel and should be capable of withstanding 325°C for 15 minutes.
Die attachment for power devices should utilize Gold/Tin (80/20) eutectic alloy solder and should avoid hydrogen
environment for PHEMT devices. Note that the backside of the chip is gold plated and is used as RF and DC ground.
These GaAs devices should be handled with care and stored in dry nitrogen environment to prevent contamination of
bonding surfaces. These are ESD sensitive devices and should be handled with appropriate precaution including the use of
wrist grounding straps. All die attach and wire/ribbon bond equipment must be well grounded to prevent static discharges
through the device.
Recommended wire bonding uses 3mils wide and 0.5mil thick gold ribbon with lengths as short as practical allowing for
appropriate stress relief. The RF input and output bonds should be typically 0.012" long corresponding to a typical 2mil gap
between the chip and the substrate material.
GATE SUPPLY
(Vg)
RF IN
MMIC CHIP
RF OUT
GROUND
(Back of the Chip)
DRAIN SUPPLY
(Vd)
Figure 1. Functional Block Diagram
2.997
2.812
2.714
1.692
1.492
1.292
0.0 0.454
Dimensions in mm
1.422
2.513
0.270
0.172
0.0
3.891
4.000
Figure 2. Chip Layout and Bond Pad Locations
(Chip Size is 4.000mm x 2.997mm x 50µm. Back of chip is RF and DC Ground)
©2004 Fairchild Semiconductor Corporation
RMPA29200 Rev. D
Share Link: 