DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

IT66121FN View Datasheet(PDF) - ITE Tech. INC.

Part Name
Description
Manufacturer
IT66121FN
ITE
ITE Tech. INC. ITE
IT66121FN Datasheet PDF : 39 Pages
First Prev 11 12 13 14 15 16 17 18 19 20 Next Last
IT66121FN
High-Bit-Rate (HBR) Audio is first introduced in the HDMI 1.3 standard. It is called upon by high-end
audio system such as DTS-HD and Dolby TrueHD. No specific interface is defined by the HBR
standard. The IT66121 supports HBR audio in two ways. One is to employ the four I2S inputs
simultaneously, where the original streaming HBR audio is broken into four parallel data streams
before entering the IT66121. The other is to use the S/PDIF input port. Since the data rate here is as
high as 98.304Mbps, a coherent MCLK is required in this application.
Interrupt Generation
The system micro-controller should take in the interrupt signal output by IT66121 at PIN 10 (INT). INT
pin can be configured as Push-pull or Tristate mode depending on user’s application. IT66121
generates an interrupt signal with events involving the following signals or situations:
1. Hot-plug detection (Pin 14, HPD) experiences state changes.
2. Receiver detection circuit reports the presence or absence of an active termination at the TMDS
Clock Channel (RxSENDetect)
3. DDC bus is hanged for any reasons
4. Audio FIFO overflows
5. HDCP authentication fails
6. Audio/Video data is stable or not
A typical initialization of HDMI link should be based on interrupt signal and appropriate register probing.
Recommended flow is detailed in IT66121 Programming Guide. Simply put, the microcontroller should
monitor the HPD status first. Upon valid HPD event, move on to check RxSENDetect register to see if
the receiver chip is ready for further handshaking. When RxSENDetect is asserted, start reading EDID
data through DDC channels and carry on the rest of the handshaking subsequently.
If the micro-controller makes no use of the interrupt signal as well as the above-mentioned status
registers, the link establishment might fail. Please do follow the suggested initialization flow
recommended in IT66121 Programming Guide.
www.ite.com.tw
Nov-2011 Rev:0.99 11/39

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]