MB84VD2008 View Datasheet(PDF) - Fujitsu
Part Name
Description
Manufacturer
MB84VD2008 Datasheet PDF : 30 Pages
| |||
MB84VD2008-10/MB84VD2009-10
Table 7 Flash Memory Command Definitions
Com-
mand
Sequence
Bus
Write
Cycles
Reqโd
First Bus Second Bus
Write Cycle Write Cycle
Addr. Data Addr. Data
Third Bus
Write Cycle
Addr. Data
Fourth Bus
Read/Write
Cycle
Addr. Data
Fifth Bus
Write Cycle
Addr. Data
Sixth Bus
Write Cycle
Addr. Data
Read/Reset 1 XXXH F0H โ โ โ โ โ โ โ โ โ โ
Read/Reset 3 555H AAH 2AAH 55H 555H F0H RA RD โ โ โ โ
Autoselect
3
555H
AAH 2AAH
55H
(BA)
555H
90H
โ
โ
โ
โ
โ
โ
Program
4 555H AAH 2AAH 55H 555H A0H PA PD โ โ โ โ
Chip Erase
6 555H AAH 2AAH 55H 555H 80H 555H AAH 2AAH 55H 555H 10H
Sector Erase 6 555H AAH 2AAH 55H 555H 80H 555H AAH 2AAH 55H SA 30H
Erase
Suspend
1
BA B0H โ โ โ โ โ โ โ โ โ โ
Erase
Resume
1 BA 30H โ โ โ โ โ โ โ โ โ โ
Set to
Fast Mode
3 555H AAH 2AAH 55H 555H 20H โ โ โ โ โ โ
Fast
Program *
2 XXXH A0H PA PD โ โ โ โ โ โ โ โ
Reset from
Fast Mode *
2
BA 90H XXXH F0H โ โ โ โ โ โ โ โ
Extended
Sector
Protect
4 XXXH 60H SPA 60H SPA 40H SPA SD โ โ โ โ
Notes: 1. Address bits A11 to A18 = X = โHโ or โLโ for all address commands except or Program Address (PA), Sector
Address (SA), and Bank Address (BA).
2. Bus operations are defined in Tables 2 and 3.
3. RA = Address of the memory location to be read
PA = Address of the memory location to be programmed
Addresses are latched on the falling edge of the write pulse.
SA = Address of the sector to be erased. The combination of A18, A17, A16, A15, A14, A13, and A12 will
uniquely select any sector.
BA = Bank Address (A16 to A18)
4. RD = Data read from location RA during read operation.
PD = Data to be programmed at location PA. Data is latched on the falling edge of write pulse.
5. SPA =Sector address to be protected. Set sector address (SA) and (A6, A1, A0) = (0, 1, 0).
SD = Sector protection verify data. Output 01H at protected sector addresses and output 00H at
unprotected sector addresses.
* : This command is valid while Fast Mode.
9
Share Link: 