MT6162
TRANSMITTER SYSTEM
All transmitter characteristics are applicable for all TX frequency bands when operated under the recommended operating
conditions and transmitter pin configuration#1, unless stated otherwise. Measured with 50ohm load at driver output; Input at BB is
DC coupled (High Zin). In 3G and GGE modes, I/Q inputs are driven each with 185mVrms DIFF signal (WCDMA UL 12.2kbps
reference channel) and 180mVrms (8PSK), respectively. The reference oscillator used with the on-chip PLL is 26MHz.
Typical specifications are for mid-band channel frequency, and recommended operating conditions. Min/Max specifications are for
Extreme operating voltage and temperature conditions, unless otherwise stated.
Table 12
Parameter
Symbol Min Typ Max Unit Test Conditions / Comments
3G Transmitter Output
Output Return Loss
Max Output Power
All bands, except Band II
Band II only
Min Output Power
(HB)
(LB)
S22
Pmax
Pmax
Pmin
Konka_WCX -12 -10 dB 50Ω load
2.5
dBm Worst case ACLR, EVM, noise emissions,
4.5
dBm and spurious emissions specs. are met
-82 dBm
Pmin
-81 dBm
RF output Frequency response
ΔP
±0.2 ±0.7 dB Pout = min.Pmax
ACLR1
±5MHz offset;
(HB)
(LB)
All bands
ACLR1
ACLR1
ACLR1
-48 -43 dBc Pout = min.Pmax
-50 -41 dBc Pout = min.Pmax
-52 -48 dBc Pout = min.Pmax – 11dB
ACLR2
ACLR2
-71 -65 dBc ±10MHz offset; Pout = = min.Pmax
EVM
Measured over 1 slot/2560chips, after Tx
I/Q imbalance and LO leakage calibration
(HB)
(LB)
EVM
EVM
2.0 3.0
2.0 3.0
1.5 2.3
1.5 2.3
% Pout= min.Pmax
% Pout= min.Pmax -11dB
% Pout= min.Pmax
% Pout= min.Pmax -11dB
Spectrum Emission Mask
(HB)
SEM
Pout= min.Pmax; 3.5M offset in 30kHz BW
-60 -56 dBc Note A
(LB)
-65 -61 dBc Note A
Carrier Suppression
-20 dBc Pout ≥ min.Pmax -44dB; before calibration
-48 -35 dBc Pout= min.Pmax; after calibration
-39 -31 dBc Pout= min.Pmax -44dB; after calibration
Sideband Suppression
-45 -38 dBc Pout ≥ min.Pmax -44dB; after calibration
Harmonic Emissions in 1 MHz
2nd harmonic
-25 dBc Pout= min.Pmax
Konka_WCX 3rd harmonic
4th harmonic
Ref. clock harmonics
-15 dBc Pout= min.Pmax
-25 dBc Pout= min.Pmax
-90 -70 dBc 52MHz; 104MHz; 208MHz
Note A: NTC1: Nominal Test Conditions (Low, Mid, High frequency channels; +15C … +35C ambient temperature; Vbat = 3.6 – 4.0V)
REV. (1.5) Mar 20th 2011
- 15 - MediaTek Proprietary & Confidential Information