ACT8846
Rev 1, 15-May-13
LOW-INPUT VOLTAGE LDO ELECTRICAL CHARACTERISTICS
(VINL3 = 3.6V, COUT10 = COUT11 = COUT12 = 2.2µF, TA = 25°C, unless otherwise specified.)
PARAMETER
TEST CONDITIONS
Operating Voltage Range
Output Voltage Accuracy
VOUT ≥ 1.0V, IOUT = 10mA
VOUT < 1.0V, IOUT = 10mA
Line Regulation
Load Regulation
Power Supply Rejection Ratio
Supply Current per Output
Soft-Start Period
Power Good Threshold
Power Good Hysteresis
Output Noise
Discharge Resistance
LDO rated at 150mA (REG10)
Dropout Voltagee
VINL = Max (VOUT + 0.5V, 3.6V) to 5.5V
IOUT = 1mA to IMAX2
f = 1kHz, IOUT = 20mA, VOUT = 1.2V
f = 10kHz, IOUT = 20mA, VOUT = 1.2V
Regulator Enabled
Regulator Disabled
VOUT = 3.0V
VOUT Rising
VOUT Falling
IOUT = 20mA, f = 10Hz to 100kHz, VOUT =
1.2V
LDO Disabled, DIS[ ] = 1
IOUT = 80mA, VOUT > 3.1V
Maximum Output Current
Current Limitf
VOUT = 95% of regulation voltage
Recommend Output Capacitor
MIN TYP MAX
1.7
5.5
-1
VNOMc
1
-10
10
0.5
0.1
50
40
22
0
2
100
92
3.5
30
1.5
100 200
150
180
2.2
LDO rated at 350mA (REG11 & REG12)
Dropout Voltagee
IOUT = 160mA, VOUT > 3.1V
Maximum Output Current
Current Limitf
VOUT = 95% of regulation voltage
Recommend Output Capacitor
100 200
350
400
2.2
UNIT
V
%
mV
mV
V/A
dB
µA
µs
%
%
µVRMS
kΩ
mV
mA
mA
µF
mV
mA
mA
µF
c: VNOM refers to the nominal output voltage level for VOUT as defined by the Ordering Information section.
2: IMAX Maximum Output Current.
3: Dropout Voltage is defined as the differential voltage between input and output when the output voltage drops 100mV below the
regulation voltage (for 3.1V output voltage or higher).
f: LDO current limit is defined as the output current at which the output voltage drops to 95% of the respective regulation voltage.
Under heavy overload conditions the output current limit folds back by 50% (typ)
Innovative PowerTM
- 20 -
Active-Semi Proprietary―For Authorized Recipients and Customers
ActivePMUTM is a trademark of Active-Semi.
I2CTM is a trademark of NXP.
www.active-semi.com
Copyright © 2013 Active-Semi, Inc.