AT89C5131A-M(2005) View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

AT89C5131A-M
(Rev.:2005)

8-bit Flash Microcontroller with Full Speed USB Device

Atmel Corporation 

Features

• 80C52X2 Core (6 Clocks per Instruction)

– Maximum Core Frequency 48 MHz in X1 Mode, 24MHz in X2 Mode

– Dual Data Pointer

– Full-duplex Enhanced UART (EUART)

– Three 16-bit Timer/Counters: T0, T1 and T2

– 256 Bytes of Scratchpad RAM

• 16/32-Kbyte On-chip Flash In-System Programming through USB

– Byte and Page (128 bytes) Erase and Write

– 100k Write Cycles

• 4-Kbyte EEPROM for Bootloader (3-Kbyte) and Data (1-Kbyte)

– Byte and Page (128 bytes) Erase and Write

– 100k Write Cycles

• On-chip Expanded RAM (ERAM): 1024 Bytes

• Integrated Power Monitor (POR/PFD) to Supervise Internal Power Supply

• USB 1.1 and 2.0 Full Speed Compliant Module with Interrupt on Transfer Completion

– Endpoint 0 for Control Transfers: 32-byte FIFO

– 6 Programmable Endpoints with In or Out Directions and with Bulk, Interrupt or

Isochronous Transfers

Endpoint 1, 2, 3: 32-byte FIFO

Endpoint 4, 5: 2 x 64-byte FIFO with Double Buffering (Ping-pong Mode)

Endpoint 6: 2 x 512-byte FIFO with Double Buffering (Ping-pong Mode)

– Suspend/Resume Interrupts

– 48 MHz PLL for Full-speed Bus Operation

– Bus Disconnection on Microcontroller Request

• 5 Channels Programmable Counter Array (PCA) with 16-bit Counter, High-speed

Output, Compare/Capture, PWM and Watchdog Timer Capabilities

• Programmable Hardware Watchdog Timer (One-time Enabled with Reset-out): 100 ms

to 3s at 8 MHz

• Keyboard Interrupt Interface on Port P1 (8 Bits)

• TWI (Two Wire Interface) 400Kbit/s

• SPI Interface (Master/Slave Mode)

• 34 I/O Pins

• 4 Direct-drive LED Outputs with Programmable Current Sources: 2-6-10 mA Typical

• 4-level Priority Interrupt System (11 sources)

• Idle and Power-down Modes

• 0 to 24 MHz On-chip Oscillator with Analog PLL for 48 MHz Synthesis

• Industrial Temperature Range

• Extended Range Power Supply: 2.7V to 5.5V (3.3V to 5.5V required for USB)

• Packages: PLCC52, VQFP64, QFN32

8-bit Flash

Microcontroller

with Full Speed

USB Device

AT89C5130A-M

AT89C5131A-M

Rev. 4337C–USB–02/05

Share Link: