BTS5180-2EKA
General Product Characteristics
Table 2 Absolute Maximum Ratings (cont’d)1)
TJ = -40°C to +150°C; (unless otherwise specified)
Parameter
Symbol
Min.
Values
Typ. Max.
Unit Note /
Number
Test Condition
Maximum energy dissipation EAS
Single pulse (one channel)
Voltage at power transistor VDS
Currents
–
–
30
mJ IL(0) = 1 A
P_4.1.23
TJ(0) = 150 °C
VS = 13.5 V
–
–
41
V
–
P_4.1.26
Current through ground pin I GND
-10 –
-150
10
mA –
20
t < 2 min
P_4.1.27
Temperatures
Junction temperature
Storage temperature
ESD Susceptibility
TJ
TSTG
-40 –
-55 –
150 °C –
150 °C –
P_4.1.28
P_4.1.30
ESD susceptibility (all pins)
ESD susceptibility OUT Pin
vs. GND and VS connected
ESD susceptibility
ESD susceptibility pin
(corner pins)
VESD
VESD
VESD
VESD
-2
–
-4
–
-500 –
-750 –
2
kV
5) HBM
4
kV
5) HBM
500 V
750 V
6) CDM
6) CDM
P_4.1.31
P_4.1.32
P_4.1.33
P_4.1.34
1) Not subject to production test. Specified by design.
2) Hardware set-up in accordance to AEC Q100-012 and AEC Q101-006.
3) VS(LD) is setup without the DUT connected to the generator per ISO 7637-1.
4) EOL tests according to AECQ100-012. Threshold limit for short circuit failures: 100 ppm. Please refer to the legal disclaimer
for short-circuit capability on Page 54 of this document.
5) ESD susceptibility HBM according to EIA/JESD 22-A 114B.
6) “CDM” EIA/JESD22-C101 or ESDA STM5.3.1
Notes
1. Stresses above the ones listed here may cause permanent damage to the device. Exposure to absolute
maximum rating conditions for extended periods may affect device reliability.
2. Integrated protection functions are designed to prevent IC destruction under fault conditions described in the
data sheet. Fault conditions are considered as “outside” normal operating range. Protection functions are not
designed for continuous repetitive operation.
Data Sheet
PROFET™+ 12V
10
Rev. 2.1, 2011-09-01