LPC1817JBD144 View Datasheet(PDF) - NXP Semiconductors.
Part Name
Description
Manufacturer
LPC1817JBD144
NXP Semiconductors.
LPC1817JBD144 Datasheet PDF : 155 Pages
| |||
NXP Semiconductors
Table 3. Pin description …continued
Pin name
LPC185x/3x/2x/1x
32-bit ARM Cortex-M3 microcontroller
Description
P1_5
P1_6
P1_7
R5 J4
48 65 [2] N; I/O GPIO1[8] — General purpose digital input/output pin.
PU O CTOUT_10 — SCTimer/PWM output 10. Match output 3 of
timer 3.
- R — Function reserved.
O EMC_CS0 — LOW active Chip Select 0 signal.
I USB0_PWR_FAULT — Port power fault signal indicating
overcurrent condition; this signal monitors over-current on the
USB bus (external circuitry required to detect over-current
condition).
I/O SSP1_SSEL — Slave Select for SSP1.
- R — Function reserved.
O SD_POW — SD/MMC card power monitor output.
T4 K4 49 67 [2] N; I/O GPIO1[9] — General purpose digital input/output pin.
PU I CTIN_5 — SCTimer/PWM input 5. Capture input 2 of timer 2.
- R — Function reserved.
O EMC_WE — LOW active Write Enable signal.
- R — Function reserved.
O EMC_BLS0 — LOW active Byte Lane select signal 0.
- R — Function reserved.
I/O SD_CMD — SD/MMC command signal.
T5 G4 50 69 [2] N; I/O GPIO1[0] — General purpose digital input/output pin.
PU I U1_DSR — Data Set Ready input for UART1.
O CTOUT_13 — SCTimer/PWM output 13. Match output 3 of
timer 3.
I/O EMC_D0 — External memory data line 0.
O USB0_PPWR — VBUS drive signal (towards external charge
pump or power management unit); indicates that VBUS must
be driven (active HIGH). Add a pull-down resistor to disable the
power switch at reset. This signal has opposite polarity
compared to the USB_PPWR used on other NXP LPC parts.
- R — Function reserved.
- R — Function reserved.
- R — Function reserved.
LPC185X_3X_2X_1X
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 5.2 — 8 March 2016
© NXP B.V. 2016. All rights reserved.
10 of 155
Share Link: