STM8S003F3P6 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM8S003F3P6

Value line, 16-MHz STM8S 8-bit MCU, 8-Kbyte Flash memory, 128-byte data EEPROM, 10-bit ADC, 3 timers, UART, SPI, I²C

STMicroelectronics 

STM8S003F3 STM8S003K3

Value line, 16-MHz STM8S 8-bit MCU, 8-Kbyte Flash memory,

128-byte data EEPROM, 10-bit ADC, 3 timers, UART, SPI, I²C

Datasheet - production data

Features

Core

• 16 MHz advanced STM8 core with Harvard

architecture and 3-stage pipeline

• Extended instruction set

Memories

• Program memory: 8 Kbyte Flash memory; data

retention 20 years at 55 °C after 100 cycles

• RAM: 1 Kbyte

• Data memory: 128 bytes true data EEPROM;

endurance up to 100 k write/erase cycles

Clock, reset and supply management

• 2.95 V to 5.5 V operating voltage

• Flexible clock control, 4 master clock sources

– Low-power crystal resonator oscillator

– External clock input

– Internal, user-trimmable 16 MHz RC

– Internal low-power 128 kHz RC

• Clock security system with clock monitor

• Power management

– Low-power modes (wait, active-halt, halt)

– Switch-off peripheral clocks individually

– Permanently active, low-consumption

power-on and power-down reset

Interrupt management

• Nested interrupt controller with 32 interrupts

• Up to 27 external interrupts on 6 vectors

LQFP32

7x7 mm

TSSOP20

6.5x6.4 mm

UFQFPN20

3x3 mm

Timers

• Advanced control timer: 16-bit, 4 CAPCOM

channels, 3 complementary outputs, dead-time

insertion and flexible synchronization

• 16-bit general purpose timer, with 3 CAPCOM

channels (IC, OC or PWM)

• 8-bit basic timer with 8-bit prescaler

• Auto wakeup timer

• Window and independent watchdog timers

Communications interfaces

• UART with clock output for synchronous

operation, SmartCard, IrDA, LIN master mode

• SPI interface up to 8 Mbit/s

• I2C interface up to 400 Kbit/s

Analog to digital converter (ADC)

• 10-bit ADC, ± 1 LSB ADC with up to 5

multiplexed channels, scan mode and analog

watchdog

I/Os

• Up to 28 I/Os on a 32-pin package including 21

high-sink outputs

• Highly robust I/O design, immune against

current injection

Development support

• Embedded single-wire interface module

(SWIM) for fast on-chip programming and non-

intrusive debugging

August 2018

This is information on a product in full production.

DS7147 Rev 10

1/103

www.st.com

Share Link: