NT5CB128M8DN View Datasheet(PDF) - Nanya Technology

Part Name

Description

Manufacturer

NT5CB128M8DN

1Gb DDR3 D-die SDRAM

Nanya Technology 

NT5CB128M8DN/NT5CB64M16DP

NT5CC128M8DN/NT5CC64M16DP

1Gb DDR3 D-die SDRAM

CAS Latency

The CAS Latency is defined by MR0 (bit A9~A11) as shown in the MR0 Definition figure. CAS Latency is the delay, in clock

cycles, between the internal Read command and the availability of the first bit of output data. DDR3/L SDRAM does not

support any half clock latencies. The overall Read Latency (RL) is defined as Additive Latency (AL) + CAS Latency (CL);

RL = AL + CL.

Test Mode

The normal operating mode is selected by MR0 (bit7=0) and all other bits set to the desired values shown in the MR0

definition figure. Programming bit A7 to a ‘1’ places the DDR3/L SDRAM into a test mode that is only used by the DRAM

manufacturer and should not be used. No operations or functionality is guaranteed if A7=1.

DLL Reset

The DLL Reset bit is self-clearing, meaning it returns back to the value of ‘0’ after the DLL reset function has been issued.

Once the DLL is enabled, a subsequent DLL Reset should be applied. Anytime the DLL reset function is used, tDLLK must

be met before any functions that require the DLL can be used (i.e. Read commands or ODT synchronous operations.)

Write Recovery

The programmed WR value MR0(bits A9, A10, and A11) is used for the auto precharge feature along with tRP to determine

tDAL WR (write recovery for auto-precharge)min in clock cycles is calculated by dividing tWR(ns) by tCK(ns) and rounding

up to the next integer: WRmin[cycles] = Roundup(tWR[ns]/tCK[ns]). The WR must be programmed to be equal or larger

than tWR (min).

Precharge PD DLL

MR0 (bit A12) is used to select the DLL usage during precharge power-down mode. When MR0 (A12=0), or ‘slow-exit’, the

DLL is frozen after entering precharge power-down (for potential power savings) and upon exit requires tXPDLL to be met

prior to the next valid command. When MR0 (A12=1), or ‘fast-exit’, the DLL is maintained after entering precharge

power-down and upon exiting power-down requires tXP to be met prior to the next valid command.

REV 1.2

May. 2011

CONSUMER DRAM

© NANYA TECHNOLOGY CORP.

All rights reserved

NANYA TECHNOLOGY CORP. reserves the right to change Products and Specifications without notice.

Share Link: