MAC7101CPV50 View Datasheet(PDF) - Freescale Semiconductor

Part Name

Description

Manufacturer

MAC7101CPV50

Microcontroller Family Hardware Specifications

Freescale Semiconductor 

Electrical Characteristics

3.4.2 Oscillator Pins

The pins XFC, EXTAL, XTAL are dedicated to the oscillator and operate at a nominal level of 2.5V.

3.5 Input/Output Characteristics

This section describes the characteristics of all I/O pins in both 3.3 V and 5 V operating conditions. All

parameters are not always applicable; for example, not all pins feature pull up/down resistances.

Table 8. 5.0 V I/O Characteristics

Conditions shown in Table 7 unless otherwise noted

Num C

Rating

Symbol Min

Typ

Max Unit

D1a P Input High Voltage

D1b T Input High Voltage

VIH

0.65 ×

VDD5 1

—

—

V

VIH

—

—

VDD5 +

V

0.3 1

D2a P Input Low Voltage

D2b T Input Low Voltage

VIL

—

— 0.35 ×

V

VDD5 1

VIL VSS5 –

—

—

V

0.3 1

D3 C Input Hysteresis

VHYS

—

250

—

mV

D4 P Input Leakage Current (pins in high impedance input mode)

Vin = VDD5 or VSS5 1

Iin

–1 2

—

12

μA

D5 P Output High Voltage (pins in output mode)

Partial Drive IOH = –2mA

VOH VDD5 –

—

—

V

0.8

Full Drive IOH = –10mA

D6 P Output Low Voltage (pins in output mode)

Partial Drive IOL = +2mA

Full Drive IOL = +10mA

VOL

—

—

0.8

V

D7 P Internal Pull Up Device Current,

tested at VIL Max.

D8 P Internal Pull Up Device Current,

tested at VIH Min.

D9 P Internal Pull Down Device Current,

tested at VIH Min.

D10 P Internal Pull Down Device Current,

tested at VIL Max.

D11 D Input Capacitance

D12 T Injection current 3

Single Pin limit

Total Device Limit. Sum of all injected currents

D13 P Port Interrupt Input Pulse filtered 4

D14 P Port Interrupt Input Pulse passed 4

IPUL

—

—

–130

μA

IPUH

–10

—

—

μA

IPDH

—

—

130

μA

IPDL

10

—

—

μA

Cin

—

6

—

IICS

–2.5

IICP

–25

tPULSE

—

—

tPULSE

10

—

—

pF

mA

2.5

25

3

μs

—

μs

NOTES:

1. Refer to Section 3.7, “Power Supply,” for definition of VSS5 and VDD5.

2. Maximum leakage current occurs at maximum operating temperature. Current decreases by approximately one-half

for each 8°C to 12°C in the temperature range from 50°C to 125°C.

3. Refer to Section 3.7.1, “Current Injection,” for more details

4. Parameter only applies in STOP or Pseudo STOP mode.

MAC7100 Microcontroller Family Hardware Specifications, Rev. 1.2

Freescale Semiconductor

Preliminary

7

Share Link: