LC876694B View Datasheet(PDF) - SANYO -> Panasonic

Part Name

Description

Manufacturer

LC876694B

8-Bit Single-Chip Microcontroller

SANYO -> Panasonic 

LC876694B/78B/62B

(10) Serial-interface

- SIO 0: 8 bit synchronous serial Interface

1) LSB first / MSB first function available

2) Internal 8 bit baud-rate generator (maximum transmit clock period 4 / 3 Tcyc)

3) Continuous automatic data communication (1-256 bits)

- SIO 1: 8 bit asynchronous / synchronous serial interface

Mode 0: Synchronous 8 bit serial IO (2-wire or 3-wire, transmit clock 2–512 Tcyc)

Mode 1: Asynchronous serial IO (half duplex, 8 data bits, 1 stop bit, baud rate 8–2048Tcyc)

Mode 2: Bus mode 1 (start bit, 8 data bits, transmit clock 2–512 Tcyc)

Mode 3: Bus mode 2 (start detection, 8 data bits, stop detection)

(11) AD converter

-8 bits × 12 channels

(12) Remote control receiver circuit (connected to P73 / INT3 / T0IN terminal)

-Noise rejection function (noise rejection filter time constant can selected from 1 / 32 / 128 Tcyc)

(13) Watchdog timer

- The watching timer period is set using an external RC.

- Watchdog timer can produce interrupt, system reset

(14) Interrupts: 15-source, 10-vectored interrupts

1) Three priority (low, high and highest) multiple interrupts are supported. During interrupt handling, an equal or

lower priority interrupt request is refused.

2) If interrupt requests to two or more vector addresses occur at once, the higher priority interrupt takes precedence.

In the case of equal priority levels, the vector with the lowest address takes precedence.

(15) Subroutine stack levels: 1024 levels max. Stack is located in RAM.

(16) Multiplication and division

- 16 bit × 8 bit (executed in 5 cycles)

- 24 bit × 16 bit (12 cycles)

- 16 bit ÷ 8 bit (8 cycles)

- 24 bit ÷ 16 bit (12 cycles)

(17) Oscillation circuits

- On-chip RC oscillation circuit for system clock use.

- On-chip CF oscillation circuit for system clock use. (Rf built in)

- On-chip Crystal oscillation circuit low speed system clock use. (Rd, Rf external)

(18) System clock divider function

- Able to reduce current consumption

Available minimum instruction cycle time: 300ns, 600ns, 1.2µs, 4.8µs, 9.6µs, 19.2µs, 38.4µs, 76.8µs.

(Using 10MHz main clock)

No.6843-3/23

Share Link: