LH28F008SC-L120 View Datasheet(PDF) - Sharp Electronics

Part Name

Description

Manufacturer

LH28F008SC-L120

Flash Memory 8M (1MB × 8)

Sharp Electronics 

sharp

LHF08CH1

16

Table 7. Status Register Definition

WSMS

ESS

ECLBS

BWSLBS

VPPS

BWSS

DPS

R

7

6

5

4

3

2

1

0

NOTES:

SR.7 = WRITE STATE MACHINE STATUS

1 = Ready

0 = Busy

Check RY/BY# or SR.7 to determine block erase, byte

write, or lock-bit configuration completion.

SR.6-0 are invalid while SR.7="0".

SR.6 = ERASE SUSPEND STATUS

1 = Block Erase Suspended

0 = Block Erase in Progress/Completed

If both SR.5 and SR.4 are "1"s after a block erase or

lock-bit configuration attempt, an improper command

sequence was entered.

SR.5 = ERASE AND CLEAR LOCK-BITS STATUS

1 = Error in Block Erasure or Clear Lock-Bits

0 = Successful Block Erase or Clear Lock-Bits

SR.3 does not provide a continuous indication of VPP

level. The WSM interrogates and indicates the VPP level

only after Block Erase, Byte Write, Set Block/Master

Lock-Bit, or Clear Block Lock-Bits command sequences.

SR.4 = BYTE WRITE AND SET LOCK-BIT STATUS SR.3 is not guaranteed to reports accurate feedback

1 = Error in Byte Write or Set Master/Block Lock-Bit only when VPP≠VPPH1/2/3.

0 = Successful Byte Write or Set Master/Block

Lock-Bit

SR.1 does not provide a continuous indication of master

SR.3 = VPP STATUS

1 = VPP Low Detect, Operation Abort

0 = VPP OK

and block lock-bit values. The WSM interrogates the

master lock-bit, block lock-bit, and RP# only after Block

Erase, Byte Write, or Lock-Bit configuration command

sequences. It informs the system, depending on the

SR.2 = BYTE WRITE SUSPEND STATUS

1 = Byte Write Suspended

0 = Byte Write in Progress/Completed

attempted operation, if the block lock-bit is set, master

lock-bit is set, and/or RP# is not VHH. Reading the block

lock and master lock configuration codes after writing

the Read Identifier Codes command indicates master

SR.1 = DEVICE PROTECT STATUS

and block lock-bit status.

1 = Master Lock-Bit, Block Lock-Bit and/or RP# Lock SR.0 is reserved for future use and should be masked

Detected, Operation Abort

out when polling the status register.

0 = Unlock

SR.0 = RESERVED FOR FUTURE ENHANCEMENTS

Rev. 1.3

Share Link: