INT202PFI2 View Datasheet(PDF) - Power Integrations, Inc
Part Name
Description
Manufacturer
INT202PFI2 Datasheet PDF : 12 Pages
| |||
INT202 Functional Description
5 V Regulator
The 5 V linear regulator circuit provides
the supply voltage for the control logic
and high-voltage level shift circuit. This
allows the logic section to be directly
compatible with 5 V CMOS logic
without the need of an external 5 V
supply.
Undervoltage Lockout
The undervoltage lockout circuit disables
the LS OUT pin and both HSD pins
whenever the V power supply falls
DD
below typically 9.0 V, and maintains
this condition until the VDD power supply
rises above typically 9.35 V. This
guarantees that both MOSFETs will
remain off during power-up or fault
conditions.
HSD1/HSD2
The HSD1 and HSD2 outputs are
connected to integrated high-voltage N-
channel MOSFET transistors which
perform the level-shifting function for
communication to the high-side driver.
Controlled current capability allows the
drain voltage to float with the high-side
driver. Two individual channels produce
a true differential communication
channel for accurately controlling the
high-side driver in the presence of fast
moving high-voltage waveforms.
INT202
Pulse Circuit
The pulse circuit provides the two high-
voltage level shifters with precise timing
signals. Two pulses are sent over HSD1
to signal the high-side driver to turn on.
One pulse is sent over HSD2 to signal
the high-side driver to turn off. The
combination of differential
communication with the precise timing
provides maximum immunity to noise.
Driver
The CMOS drive circuit provides drive
power to the gate of the MOSFET used
on the low side of the half bridge circuit.
The driver consists of a CMOS buffer
capable of driving an external transistor
gate at up to 15 V.
HV+
C2
D1
VDD
C1
CONTROL
8
76
5
INT201
1
23
4
R2
Q2
8
76
5
INT202
1
23
4
R1
Q1
D3
PHASE 1
D2
HV-
Figure 4. Using the INT202 and INT201 to Drive a Switched Reluctance Motor.
PHASE 2
3-PHASE
SRM
PHASE 3
PI-1473-042695
3 F
2/96
Share Link: 