SM1350ADJM
Level hold melody output (LH=HIGH)
Level hold melody output is played when STN is LOW, and it goes HIGH, it is melody control which stops in the
middle of melody. When either of S0 to S3 changes during melody output, it restarts from the head of the melody newly
selected.
* This function is effective only while the level hold melody output in the binary select mode.
STN
S0 to S3
Melody Output
(SP pin)
#N
#M
#N
#M
Figure 7. Level hold mode
Binary select mode (MODE=LOW)
A melody of 1 to 16 is selected according to the condition (0000 to 1111) of S0 to S3.
Serial select mode (MODE=HIGH)
In serial select mode, the next melody is selected by cycling through the melodies in the order N→N
1…N-1→N when the STN input goes LOW. Note that when melody output is stopped using the STOP input, the
melody-select counter increments.
One-shot melody output (LH=LOW)
STN
Melody Output
(SP pin)
#N
#N+1
Figure 8. One-shot mode (serial select)
#N+2
Level hold melody output (LH=HIGH)
STN
Melody Output
(SP pin)
#N
#N+1
Figure 9. Level hold mode (serial select)
#N+1
SEIKO NPC CORPORATION - 10