Efficiency VS Input Voltage curve
(Full Load)
B1212S-2WR2
100
95
90
85
80
75
70
65
60
55
50
Input Voltage(V)
Efficiency VS Output Load curve
(Vin=Vin-nominal)
B1212S-2WR2
100
90
80
70
60
50
40
30
20
10
0
10 20 30 40 50 60 70 80 90 100
Total Output Current (% )
DIMENSIONS, RECOMMENDED FOOTPRINT & PACKAGING
TEST CONFIGURATIONS
Input Reflected-Ripple Current Test Setup
Input reflected-ripple current is measured with an inductor Lin and Capacitor Cin to simulate source impedance.
Oscilloscope
Lin
DC DC Current
Cin Probe
Load
Lin(4.7µH) Cin(220µF, ESR < 1.0Ω at 100 KHz)
DESIGN CONSIDERATIONS
1) Requirement on output load
To ensure this module can operate efficiently and reliably, During operation, the minimum output load is not less than 10% of the full load. If the
actual output power is very small, please connect a resistor with proper resistance at the output end in parallel to increase the load, or use our
company’s products with a lower rated output power.
2) Overload Protection
Under normal operating conditions, the output circuit of these products has no protection against overload. The simplest method is to add a circuit
breaker to the circuit.
The copyright and authority for the interpretation of the products are reserved by MORNSUN A_S-2WR2 & B_S-2WR2 2013.06.18- A/1 Page 4 of 5