ADSP-21160M(Rev0) View Datasheet(PDF) - Analog Devices
Part Name
Description
Manufacturer
ADSP-21160M Datasheet PDF : 52 Pages
| |||
ADSP-21160M
Table 2. Pin Function Descriptions (Continued)
Pin
TCK
TMS
TDI
TDO
TRST
EMU
CIF
VDDINT
VDDEXT
AVDD
AGND
GND
NC
Type
I
I/S
I/S
O
I/A
O (O/D)
O/T
P
P
P
G
G
Function
Test Clock (JTAG). Provides a clock for JTAG boundary scan.
Test Mode Select (JTAG). Used to control the test state machine. TMS has a 20 kΩ
internal pull-up resistor.
Test Data Input (JTAG). Provides serial data for the boundary scan logic. TDI has a
20 kΩ internal pull-up resistor.
Test Data Output (JTAG). Serial scan output of the boundary scan path.
Test Reset (JTAG). Resets the test state machine. TRST must be asserted (pulsed low)
after power-up or held low for proper operation of the ADSP-21160M. TRST has a
20 kΩ internal pull-up resistor.
Emulation Status. Must be connected to the ADSP-21160M emulator target board
connector only. EMU has a 50 kΩ internal pull-up resistor.
Core Instruction Fetch. Signal is active low when an external instruction fetch is
performed. Driven by bus master only. Three-state when host is bus master.
Core Power Supply. Nominally 2.5 V dc and supplies the DSP’s core processor
(40 pins).
I/O Power Supply. Nominally 3.3 V dc (46 pins).
Analog Power Supply. Nominally 2.5 V dc and supplies the DSP’s internal PLL (clock
generator). This pin has the same specifications as V , DDINT except that added filtering
circuitry is required. For more information, see Power Supplies on page 6.
Analog Power Supply Return.
Power Supply Return. (83 pins)
Do Not Connect. Reserved pins that must be left open and unconnected (5 pins).
Table 3. Boot Mode Selection
EBOOT
1
0
0
0
0
1
LBOOT
0
0
1
0
1
1
BMS
Output
1 (Input)
1 (Input)
0 (Input)
0 (Input)
x (Input)
Booting Mode
EPROM (Connect BMS to EPROM chip select.)
Host Processor
Link Port
No Booting. Processor executes from external memory.
Reserved
Reserved
–12–
REV. 0
Share Link: 