LC877296B View Datasheet(PDF) - SANYO -> Panasonic

Part Name

Description

Manufacturer

LC877296B

8-Bit Single-Chip Microcontroller

SANYO -> Panasonic 

LC8772C8B/B2B/96B/80B

(11) Remote control receiver circuit (connected to P73 / INT3 / T0IN terminal)

-Noise rejection function (noise rejection filter’s time constant can be selected from 1 / 32 / 128 Tcyc)

(12) Watchdog timer

- The watching time period is determined by an external RC.

- Watchdog timer can produce interrupt or system reset

(13) Interrupts: 14 sources, 10 vectors

1) Three priority (low, high and highest) multiple interrupts are supported. During interrupt handling, an equal or

lower priority interrupt request is postponed.

2) If interrupt requests to two or more vector addresses occur at once, the higher priority interrupt takes precedence.

In the case of equal priority levels, the vector with the lowest address takes precedence.

No.

Vector

Selectable Level

Interrupt signal

1

00003H

X or L

INT0

2

0000BH

3

00013H

4

0001BH

5

00023H

6

0002BH

7

00033H

8

0003BH

9

00043H

10

0004BH

X or L

H or L

H or L

H or L

H or L

H or L

H or L

H or L

H or L

INT1

INT2/T0L

INT3/Base timer

T0H

T1L/T1H

SIO0

SIO1

ADC/MIC

Port 0

• Priority Level : X > H > L

• For equal priority levels, vector with lowest address takes precedence.

(14) Subroutine stack levels: 1024 levels max. Stack is located in RAM.

(15) Multiplication and division

- 16 bit × 8 bit (executed in 5 cycles)

- 24 bit × 16 bit (12 cycles)

- 16 bit ÷ 8 bit (8 cycles)

- 24 bit ÷ 16 bit (12 cycles)

(16) Oscillation circuits

- On-chip RC oscillation for system clock use.

- CF oscillation for system clock use. (Rf built in, Rd external)

- Crystal oscillation low speed system clock use. (Rf built in, Rd external)

(17) Standby function

- HALT mode

HALT mode is used to reduce power consumption. During the HALT mode, program execution is stopped but

peripheral circuits keep operating (some parts of serial transfer operation stop.)

1) Oscillation circuits are not stopped automatically.

2) Released by the system reset or interrupts.

-HOLD mode

HOLD mode is used to reduce power consumption. Program execution and peripheral circuits are stopped.

1) CF, RC and crystal oscillation circuits stop automatically.

2) Released by any of the following conditions.

(1) Low level input to the reset pin

(2) Specified level input to one of INT0, INT1, INT2

(3) Port 0 interrupt

No.6842-3/24

Share Link: