ST7FLITE29(2003) View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST7FLITE29
(Rev.:2003)

8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI

STMicroelectronics 

ST7LITE2

DATA EEPROM (Cont’d)

5.4 POWER SAVING MODES

Wait mode

The DATA EEPROM can enter WAIT mode on ex-

ecution of the WFI instruction of the microcontrol-

ler or when the microcontroller enters Active-HALT

mode.The DATA EEPROM will immediately enter

this mode if there is no programming in progress,

otherwise the DATA EEPROM will finish the cycle

and then enter WAIT mode.

Active-Halt mode

Refer to Wait mode.

Halt mode

The DATA EEPROM immediately enters HALT

mode if the microcontroller executes the HALT in-

struction. Therefore the EEPROM will stop the

function in progress, and data may be corrupted.

5.5 ACCESS ERROR HANDLING

If a read access occurs while E2LAT=1, then the

data bus will not be driven.

If a write access occurs while E2LAT=0, then the

data on the bus will not be latched.

If a programming cycle is interrupted (by software/

RESET action), the memory data will not be guar-

anteed.

5.6 Data EEPROM Read-out Protection

The read-out protection is enabled through an op-

tion bit (see section 15.1 on page 123).

When this option is selected, the programs and

data stored in the EEPROM memory are protected

against read-out piracy (including a re-write pro-

tection). In Flash devices, when this protection is

removed by reprogramming the Option Byte, the

entire Program memeory and EEPROM is first au-

tomatically erased.

Note: Both Program Memory and data EEPROM

are protected using the same option bit.

Figure 9. Data EEPROM Programming Cycle

INTERNAL

PROGRAMMING

VOLTAGE

WRITE OF

DATA LATCHES

READ OPERATION NOT POSSIBLE

ERASE CYCLE

WRITE CYCLE

tPROG

READ OPERATION POSSIBLE

LAT

PGM

18/131

1

Share Link: