ZXCT1012(2011) View Datasheet(PDF) - Diodes Incorporated.
Part Name
Description
Manufacturer
ZXCT1012 Datasheet PDF : 9 Pages
| |||
ZXCT1012
REDUCED HEIGHT MICRO-POWER CURRENT MONITOR
Applications Information
The ZXCT1012 current monitor works by converting the voltage developed across a small sense resistor into a current on the
out pin. In reality it is a voltage to current converter. This output current can be converted into a voltage simply by passing it
through a resistor (ROUT) to ground.
The current monitor has a transconductance of 10mA/V. But the overall amplifying conversion is affected by both the RSENSE
and ROUT.
The gain equation of the ZXCT1012 is:
VOUT
=
IL
× RSENSE
ROUT
100
For best performance RSENSE should be connected as close to the SENSE+ (and SENSE-) pins; which minimizes any series
resistance with RSENSE and potential for interference pickup.
When choosing appropriate values for RSENSE a compromise must be reached between in-line signal loss (including potential
power dissipation effects) and small signal accuracy.
Higher values for RSENSE gives better accuracy at low load currents by reducing the inaccuracies due to internal offsets. For
best operation the ZXCT1012 has been designed to provide best performance with VSENSE of the order of 40mV to 200mV.
Current monitors are single supply devices which means they tend to saturate at very low sense voltages. However it does
mean the output can never go negative. Also the output can never change direction (monotonic). This is important if the
current monitor is used in a control loop.
As the sense voltage is reduced the output will tend to saturate as the input offset voltage starts to have greater effect. It is
recommended to have a minimum sense voltage of 10mV to minimize linearity errors. Diodes has specified the output voltage
at VSENSE of 10mV, 40mV, 100mV and 200mV; which is the recommended sense voltage range.
The maximum differential input voltage, VSENSE, is 2.5V; however this will cause large output currents to flow increasing power
dissipation in the chip. The sense voltage can be increased further, without damaging the ZXCT1012, by the inclusion of a
resistor, RLIM, between SENSE- pin and the load. Typical values around 10kΩ. See figure below.
RSENSE
CC
RLIM
ZXCT1012
If large reverse currents are expected then the resistor, RLIM, will provide protection from exceeding absolute maximum ratings.
A suitable value for RLIM can be determined from:
RLIM
=
VSENSE(REF)
5mA
Where VSENSE(REV) is the maximum expected reverse sense voltage generated.
ZXCT1012
Document number: DS33444 Rev. 2 - 2
5 of 9
www.diodes.com
September 2011
© Diodes Incorporated
Share Link: 