WM8510 Просмотр технического описания (PDF) - Wolfson Microelectronics plc

Номер в каталоге

Компоненты Описание

производитель

WM8510

Mono CODEC with Speaker Driver

Wolfson Microelectronics plc 

WM8510

Production Data

TERMINOLOGY

1. MICN input only in single ended microphone configuration. Maximum input signal to MICP without distortion is -3dBV.

2. Hold Time is the length of time between a signal detected being too quiet and beginning to ramp up the gain. It does

not apply to ramping down the gain when the signal is too loud, which happens without a delay.

3. Ramp-up and Ramp-Down times are defined as the time it takes the PGA to change its gain by 6dB.

4. All hold, ramp-up and ramp-down times scale proportionally with MCLK

5. Signal-to-noise ratio (dB) – SNR is a measure of the difference in level between the full scale output and the output with

no signal applied. (No Auto-zero or Automute function is employed in achieving these results).

6. THD (dB) – THD is a ratio, of the rms values, of Noise Signal.

7. The maximum output voltage can be limited by the speaker power supply. If MONOBOOST=1 then SPKVDD should

be 1.5xAVDD or higher to prevent clipping taking place in the output stage.

w

PD Rev 4.1 December 2006

8

Share Link: