ACT5830QJ1CF-T Просмотр технического описания (PDF) - Active-Semi, Inc

Номер в каталоге

Компоненты Описание

производитель

ACT5830QJ1CF-T

Twelve Channel PMU for Mobile Phones

Active-Semi, Inc 

®

ACT5830

Rev 2, 20-Jan-11

STEP-DOWN DC/DC CONVERTER

FUNCTIONAL DESCRIPTIONS CONT’D

Inductor Selection

REG utilizes current-mode control and a proprietary

internal compensation scheme to simultaneously

simplify external component selection and optimize

transient performance over its full operating range.

REG was optimized for operation with a 3.3µH

inductor, although inductors in the 2.2µH to 4.7µH

range can be used. Choose an inductor with a low

DC-resistance, and avoid inductor saturation by

choosing inductors with DC ratings that exceed the

maximum output current of the application by at least

30%.

PCB Layout Considerations

High switching frequencies and large peak currents

make PC board layout an important part of step-

down DC/DC converter design. A good design

minimizes excessive EMI on the feedback paths

and voltage gradients in the ground plane, both of

which can result in instability or regulation errors.

Step-down DC/DC exhibits discontinuous input

current, so the input capacitors should be placed as

close as possible to the IC, and avoiding the use of

vias if possible. The inductor, input filter capacitor,

and output filter capacitor should be connected as

close together as possible, with short, direct, and

wide traces. The ground nodes for each regulator's

power loop should be connected at a single point in

a star-ground configuration, and this point should

be connected to the backside ground plane with

multiple vias. The output node should be connected

to the VBUCK pin through the shortest possible

route, while keeping sufficient distance from

switching nodes to prevent noise injection. Finally,

the exposed pad should be directly connected to

the backside ground plane using multiple vias to

achieve low electrical and thermal resistance.

Innovative PowerTM

ActivePMUTM is a trademark of Active-Semi.

I2CTM is a trademark of NXP.

- 18 -

www.active-semi.com

Copyright © 2010 Active-Semi, Inc.

Share Link: