ADT7410
WRITING DATA
It is possible to write either a single byte of data or two bytes to
the ADT7410, depending on which registers are to be written.
Writing a single byte of data requires the serial bus address, the
data register address written to the address pointer register,
followed by the data byte written to the selected data register.
This is shown in Figure 15.
For the THIGH setpoint, TLOW setpoint, and TCRIT setpoint registers,
it is possible to write to both the MSB and the LSB registers in
the same write transaction. Writing two bytes of data to these
registers requires the serial bus address, the data register address
of the MSB register written to the address pointer register,
followed by the two data bytes written to the selected data
register. This is shown in Figure 16.
If more than the required number of data bytes is written to a
register, the register ignores these extra data bytes. To write to
a different register, a start or repeated start is required.
1
9
1
9
SCL
SDA
1
START BY
MASTER
0
0
1
0
A1 A0 R/W
P7
FRAME 1
SERIAL BUS ADDRESS BYTE
ACK. BY
ADT7410
1
SCL (CONTINUED)
P6 P5 P4 P3 P2 P1 P0
FRAME 2
ADDRESS POINTER REGISTER BYTE
9
ACK. BY
ADT7410
SDA (CONTINUED)
D7 D6 D5 D4 D3 D2 D1 D0
ACK. BY STOP BY
ADT7410 MASTER
FRAME 3
DATA BYTE
Figure 15. Writing to a Register Followed by a Single Byte of Data
1
9
1
9
SCL
SDA
1
0
0
1
0
A1 A0 R/W
P7 P6 P5 P4 P3 P2 P1 P0
START BY
MASTER
FRAME 1
SERIAL BUS ADDRESS BYTE
ACK. BY
ADT7410
FRAME 2
ADDRESS POINTER REGISTER BYTE
ACK. BY
ADT7410
1
9
1
9
SCL (CONTINUED)
SDA (CONTINUED)
D15 D14 D13 D12 D11 D10 D9 D8
D7 D6 D5 D4 D3 D2 D1 D0
ACK. BY
ADT7410
ACK. BY STOP BY
ADT7410 MASTER
FRAME 3
DATA BYTE
FRAME 4
DATA BYTE
Figure 16. Writing to a Register Followed by Two Bytes of Data
Rev. 0 | Page 18 of 24