EL1503A Просмотр технического описания (PDF) - Intersil
Номер в каталоге
Компоненты Описание
производитель
EL1503A Datasheet PDF : 17 Pages
| |||
EL1503A
s
Absolute Maximum Ratings (TA = +25°C)
VS+ to VS- Supply Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .28V
VS+ Voltage to Ground . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +28V
VS- Voltage to Ground . . . . . . . . . . . . . . . . . . . . . . . . . . -28V to 0.3V
Input C0/C1 to Ground . . . . . . . . . . . . . . . . . . . . . . . . . . -0.3V to +7V
Driver VIN+ Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . VS- to VS+
Current into any Input . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8mA
Output Current from Driver (static) . . . . . . . . . . . . . . . . . . . . 100mA
Operating Temperature Range . . . . . . . . . . . . . . . . .-40°C to +85°C
Storage Temperature Range . . . . . . . . . . . . . . . . . .-60°C to +150°C
Operating Junction Temperature . . . . . . . . . . . . . . .-40°C to +150°C
Power Dissipation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . See Curves
CAUTION: Stresses above those listed in “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions above those indicated in the operational sections of this specification is not implied.
IMPORTANT NOTE: All parameters having Min/Max specifications are guaranteed. Typical values are for information purposes only. Unless otherwise noted, all tests
are at the specified temperature and are pulsed tests, therefore: TJ = TC = TA
Electrical Specifications VS = ±12V, RF = 1.5kΩ, RL= 65Ω, IADJ = C0 = C1 = 0V, TA = +25°C. Amplifiers tested separately.
PARAMETER
DESCRIPTION
CONDITIONS
MIN
TYP
MAX
SUPPLY CHARACTERISTICS
IS+(Full Power) Positive Supply Current per Amplifier
IS-(Full Power) Negative Supply Current per Amplifier
IS+(Low Power) Positive Supply Current per Amplifier
IS-(Low Power) Negative Supply Current per Amplifier
IS+(Terminate) Positive Supply Current per Amplifier
IS-(Terminate)
Negative Supply Current per Amplifier
IS+(Power Down) Positive Supply Current per Amplifier
IS-(Power Down) Negative Supply Current per Amplifier
IGND
GND Supply Current per Amplifier
INPUT CHARACTERISTICS
All outputs at 0V, C0 = C1 = 0V
All outputs at 0V, C0 = C1 = 0V
All outputs at 0V, C0 = 5V, C1 = 0V
All outputs at 0V, C0 =5V, C1 = 0V
All outputs at 0V, C0 = 0V, C1 = 5V
All outputs at 0V, C0 = 0V, C1 = 5V
All outputs at 0V, C0 = C1 = 5V
All outputs at 0V, C0 = C1 = 5V
All outputs at 0V
10
12.5
16
-15
-11.5
-9
7
9
11.5
-10.5
-8
-6
4
5.1
7
-6
-4
-3
0.75
1.05
1.7
-0.5
-0.25
0.07
-1
VOS
Input Offset Voltage
ΔVOS
VOS Mismatch
IB+
Non-Inverting Input Bias Current
IB-
Inverting Input Bias Current
ΔIB-
IB- Mismatch
ROL
Transimpedance
eN
Input Noise Voltage
iN
-Input Noise Current
VIH
Input High Voltage
VIL
Input Low Voltage
IIH1
Input High Current for C1
IIH0
Input High Current for C0
IIL
Input Low Current for C1or C0
OUTPUT CHARACTERISTICS
C0 & C1 inputs
C0 & C1 inputs
C1 = 5V
C0 = 5V
C1 = 0V, C0 = 0V
-30
30
-15
15
-15
15
-50
50
-30
30
0.4
0.8
3.5
13
2.7
0.8
1.5
8
0.75
4
-1
1
VOUT
IOL
Loaded Output Swing
Linear Output Current
RL = 65Ω
RL = 22Ω
AV = 5, RL = 10Ω, f = 100kHz,
THD = --60dBc
±10.3
±9.3
±10.6
±9.8
450
IOUT
Output Current
VOUT = 1V, RL = 1Ω
1
UNIT
mA
mA
mA
mA
mA
mA
mA
mA
mA
mV
mV
µA
µA
µA
MΩ
nV/√ Hz
pA/√ Hz
V
V
µA
µA
µA
V
V
mA
A
3
FN7039.2
March 26, 2007
Share Link: 