EM78P153E Просмотр технического описания (PDF) - ELAN Microelectronics

Номер в каталоге

Компоненты Описание

производитель

EM78P153E

8-bit microprocessor designed and developed with low-power and high-speed CMOS technology

ELAN Microelectronics 

EM78P153E

OTP ROM

4. R3 (Status Register)

7

6

5

4

3

2

1

0

RST

GP1

GP0

T

P

Z

DC

C

• Bit 0 (C) Carry flag

• Bit 1 (DC) Auxiliary carry flag

• Bit 2 (Z) Zero flag.

Set to "1" if the result of an arithmetic or logic operation is zero.

• Bit 3 (P) Power down bit.

Set to 1 during power on or by a "WDTC" command and reset to 0 by a "SLEP" command.

• Bit 4 (T) Time-out bit.

Set to 1 with the "SLEP" and "WDTC" command, or during power up and reset to 0 by WDT

time-out.

• Bit5 ~ 6 (GP0 ~ 1) General-purpose read/write bits.

• Bit 7 (RST) Bit for reset type.

Set to 1 if wake-up from sleep mode on pin change.

Set to 0 if wake-up from other reset types

5. R4 (RAM Select Register)

• Bits 0~5 are used to select registers (address: 00~06, 0F~2F) in the indirect addressing mode.

• Bits 6~7 are general-purpose read/write bits.

• See the configuration of the data memory in Fig. 4.

6. R5 ~ R6 (Port 5 ~ Port 6)

• R5 and R6 are I/O registers.

• Only the lower 4 bits of R5 are available.

• The upper 4 bits of R5 are fixed to 0.

• P63 is input only.

7. RF (Interrupt Status Register)

7

6

5

4

3

2

1

0

-

-

-

-

-

EXIF

ICIF

TCIF

“1” means interrupt request, and “0” means no interrupt occurs.

• Bit 0 (TCIF) TCC overflowing interrupt flag. Set when TCC overflows, reset by software.

• Bit 1 (ICIF) Port 6 input status changed interrupt flag. Set when Port 6 input changes, reset by

software.

• Bit 2 (EXIF) External interrupt flag. Set by falling edge on /INT pin, reset by software.

This specification is subject to change without prior notice.

9

2002/03/01

Share Link: