LM358AWD Просмотр технического описания (PDF) - STMicroelectronics
Номер в каталоге
Компоненты Описание
производитель
LM358AWD Datasheet PDF : 18 Pages
| |||
LM158W-LM258W-LM358W
Absolute maximum ratings and operating conditions
2
Absolute maximum ratings and operating conditions
Table 1. Absolute maximum ratings
Symbol
Parameter
LM158W/AW LM258W/AW LM358W/AW Unit
VCC+
Vin
Vid
Iin
Toper
Tstg
Tj
Rthja
Supply voltage
Input voltage
Differential input voltage
Output short-circuit duration (1)
Input current (2)
Operating free-air temperature range
Storage temperature range
Maximum junction temperature
Thermal resistance junction to ambient(3)
SO-8
MiniSO-8
TSSOP8
DIP-8
+32
-0.3 to VCC+ +0.3
-0.3 to VCC+ +0.3
Infinite
50
-55 to +125 -40 to +105 0 to +70
-65 to +150
150
125
190
120
85
V
V
V
mA
°C
°C
°C
°C/W
Rthjc
ESD
Thermal resistance junction to case(3)
SO-8
MiniSO-8
TSSOP8
DIP-8
HBM: human body model(4)
MM: machine model(5)
CDM: charged device model(6)
40
39
°C/W
37
41
1.5
kV
200
V
1.5
kV
1. Short-circuits from the output to VCC can cause excessive heating if VCC > 15V. The maximum output current is
approximately 40 mA independent of the magnitude of VCC. Destructive dissipation can result from simultaneous short-
circuits on all amplifiers.
2. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the collector-base
junction of the input PNP transistor becoming forward biased and thereby acting as input diode clamps. In addition to this
diode action, there is also NPN parasitic action on the IC chip. This transistor action can cause the output voltages of the
Op-amps to go to the VCC voltage level (or to ground for a large overdrive) for the time during which an input is driven
negative. This is not destructive and normal output will be restored for input voltage higher than -0.3 V.
3. Short-circuits can cause excessive heating and destructive dissipation. Rth are typical values.
4. Human body model: 100 pF discharged through a 1.5 kΩ resistor between two pins of the device, done for all couples of pin
combinations with other pins floating.
5. Machine model: a 200 pF cap is charged to the specified voltage, then discharged directly between two pins of the device
with no external series resistor (internal resistor < 5 Ω), done for all couples of pin combinations with other pins floating.
6. Charged device model: all pins plus package are charged together to the specified voltage and then discharged directly to
the ground.
3/18
Share Link: 