LPC1102UK(2011) Просмотр технического описания (PDF) - NXP Semiconductors.
Номер в каталоге
Компоненты Описание
производитель
LPC1102UK
(Rev.:2011)
(Rev.:2011)
NXP Semiconductors.
LPC1102UK Datasheet PDF : 39 Pages
| |||
NXP Semiconductors
LPC1102
32-bit ARM Cortex-M0 microcontroller
Table 5. Static characteristics …continued
Tamb = 40 C to +85 C, unless otherwise specified.
Symbol
Parameter
Conditions
IOL
IOHS
LOW-level output
current
HIGH-level short-circuit
output current
VOL = 0.4 V
2.0 V VDD 3.6 V
1.8 V VDD < 2.0 V
VOH = 0 V
IOLS
LOW-level short-circuit VOL = VDD
output current
Ipd
pull-down current
Ipu
pull-up current
External clock input
VI = 5 V
VI = 0 V;
2.0 V VDD 3.6 V
1.8 V VDD < 2.0 V
VDD < VI < 5 V
Vi(xtal)
crystal input voltage
Min
4
3
[11] -
[11] -
10
15
10
0
0.5
Typ[1]
-
Max
-
-
-
-
45
-
50
50
150
50
85
50
85
0
0
1.8
1.95
Unit
mA
mA
mA
mA
A
A
A
A
V
[1] Typical ratings are not guaranteed. The values listed are at room temperature (25 C), nominal supply voltages.
[2] Tamb = 25 C.
[3] IDD measurements were performed with all pins configured as GPIO outputs driven LOW and pull-up resistors disabled.
[4] IRC enabled; external clock disabled; system PLL disabled.
[5] BOD disabled.
[6] All peripherals disabled in the SYSAHBCLKCTRL register. Peripheral clocks to UART and SPI0/1 disabled in system configuration
block. Low-current mode PWR_LOW_CURRENT selected when running the set_power routine in the power profiles.
[7] IRC disabled; system oscillator enabled; system PLL enabled.
[8] All oscillators and analog blocks turned off in the PDSLEEPCFG register; PDSLEEPCFG = 0x0000 18FF.
[9] Including voltage on outputs in 3-state mode.
[10] VDD supply voltage must be present.
[11] Allowed as long as the current limit does not exceed the maximum current allowed by the device.
LPC1102
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 4 — 24 June 2011
© NXP B.V. 2011. All rights reserved.
18 of 39
Share Link: 