IR1210 Просмотр технического описания (PDF) - International Rectifier
Номер в каталоге
Компоненты Описание
производитель
IR1210 Datasheet PDF : 5 Pages
| |||
IR1210
ADVANCED INFORMATION
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage param-
eters are absolute voltages referenced to GND. The thermal resistance and power dissipation ratings are measured
under board mounted and still air conditions.
Symbol
VS
VO
VIN
PD
RthJA
TJ
TS
TL
Definition
Fixed supply voltage
Output voltage
Logic input voltage (INA/N & INB/N)
Package power dissipation @ TA ≤ +25°C
Thermal resistance, junction to ambient
Junction temperature
Storage temperature
Lead temperature (soldering, 10 seconds)
Min.
Max. Units
-0.3
25
-0.3
VS + 0.3
V
-0.3
VS + 0.3
—
0.625
W
—
200
°C/W
—
150
-55
150
°C
—
300
Recommended Operating Conditions
The input/output logic timing diagram is shown in figure 1. For proper operation the device should be used within the
recommended conditions. All voltage parameters are absolute voltages referenced to GND.
Symbol
VS
VO
VIN
TA
Definition
Fixed supply oltage
Output voltage
Logic input voltage (INA/N & INB/N)
Ambient temperature
Min.
6
0
0
-40
Max.
20
VS
VS
125
Units
V
°C
DC Electrical Characteristics
VBIAS (VS) = 15V, TA = 25°C unless otherwise specified. The VIN, and IIN parameters are referenced to GND and are
applicable to input leads: INA/N and INB/N. The VO and IO parameters are referenced to GND and are applicable to the
output leads: OUTA and OUTB.
Symbol
VIH
VIL
VOH
VOL
IIN+
IIN-
IQS
IO+
IO-
Definition
Logic “0” input voltage (OUT=LO)
Logic “1” input voltage (OUT=HI)
High level output voltage, VBIAS-VO
Low level output voltage, VO
Logic “1” input bias current (OUT=HI)
Logic “0” input bias current (OUT=LO)
Quiescent Vs supply current
Output high short circuit pulsed current
Output low short circuit pulsed current
2
Min.
2.7
—
—
—
—
—
—
1.5
1.5
Typ. Max. Units Test Conditions
——
—
0.8
V
— 1.2
— 0.1
5
15
-10 -30
100 200
2.3 —
3.3 —
VIN = 0V
µA
VIN = VS
VIN = 0V or VS
VO = 0V, VIN = 0
A
PW ≤ 10 µs
VO = 15V, VIN = VS
PW ≤ 10 µs
www.irf.com
Share Link: 