AD7849CRZ 查看數據表（PDF） - Analog Devices
零件编号
产品描述 (功能)
生产厂家
AD7849CRZ Datasheet PDF : 20 Pages
| |||
APPLICATIONS INFORMATION
OPTO-ISOLATED INTERFACE
In many process control applications, it is necessary to provide
an isolation barrier between the controller and the unit being
controlled. Opto-isolators can provide voltage isolation in
excess of 3 kV. The serial loading structure of the AD7849
makes it ideal for opto-isolated interfaces because the number
of interface lines is kept to a minimum.
Figure 28 shows a 4-channel isolated interface using the AD7849.
The DCEN pin must be connected high to enable the daisy-chain
facility. Four channels with 14-bit or 16-bit resolution are provided
in the circuit shown, but this can be expanded to accommodate
any number of DAC channels without any extra isolation circuitry.
The only limitation is the output update rate. For example, if an
output update rate of 10 kHz is required, then all DACs must be
loaded and updated in 100 μs. Operating at the maximum clock
rate of 5 MHz means that it takes 3.2 μs to load a DAC. This means
that the total number of channels for this update rate is 31, which
leaves 800 ns for the LDAC pulse. Of course, as the update rate
requirement decreases, the number of possible channels increases.
AD7849
The sequence of events to program the output channels in
Figure 28 is as follows:
1. Take the SYNC line low.
2. Transmit the data as four 16-bit words. A total of 64 clock
pulses is required to clock the data through the chain.
3. Take the SYNC line high.
4. Pulse the LDAC line low. This updates all output channels
simultaneously on the falling edge of LDAC.
To reduce the number of optocouplers, the LDAC line can be
driven from one shot that is triggered by the rising edge on the
SYNC line. A low level pulse of 100 ns duration or greater is all
that is required to update the outputs.
DATA OUT
CLOCK OUT
SYNC OUT
CONTROL OUT
CONTROLLER
VDD
VDD
VDD
VDD
QUAD OPTO-COUPLER
SDIN
SCLK
VOUT
SYNC
AD7849*
LDAC DCEN
SDOUT
VOUTA
5V
SDIN
SCLK
VOUT
SYNC
AD7849*
LDAC DCEN
SDOUT
VOUTB
5V
SDIN
SCLK
VOUT
SYNC
AD7849*
LDAC DCEN
SDOUT
VOUTC
5V
*ADDITIONAL PINS OMITTED FOR CLARITY.
Figure 28. 4-Channel Opto-Isolated Interface
SDIN
SCLK
VOUT
SYNC
AD7849*
LDAC
DCEN
SDOUT
VOUTD
5V
Rev. C | Page 17 of 20
Share Link: 