L6910G 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

L6910G

ADJUSTABLE STEP DOWN CONTROLLER WITH SYNCHRONOUS RECTIFICATION

STMicroelectronics 

L6910G

avoided if the PHASE pin is over about 500mV. The lower mos is in any case turned-on after 200ns from the

high side turn-off.

The peak current is shown for both the upper (fig. 6) and the lower (fig. 7) driver at 5V and 12V. A 3.3nF capac-

itive load has been used in these measurements.

For the lower driver, the source peak current is 1.1A @ VCC = 12V and 500mA @ VCC = 5V, and the sink peak

current is 1.3A @ VCC = 12V and 500mA @ VCC = 5V.

Similarly, for the upper driver, the source peak current is 1.3A @ Vboot-Vphase = 12V and 600mA @ Vboot-

Vphase = 5V, and the sink peak current is 1.3A @ Vboot-Vphase =12V and 550mA @ Vboot-Vphase = 5V.

Figure 6. High Side Driver Peak Current. Vboot-Vphase = 12V (right) Vboot-Vphase = 5V (left)

CH1 = High Side Gate CH4 = Gate Current

Figure 7. Low Side Driver Peak Current. VCC = 12V (right) VCC = 5V (left)

CH1 = Low Side Gate CH4 = Gate Current

4.5 Monitoring and Protections

The output voltage is monitored by means of pin FB. If it is not within ±10% (typ.) of the programmed value, the

powergood output is forced low.

The device provides overvoltage protection, when the voltage sensed on pin FB reaches a value 17% (typ.)

greater than the reference the OSC pin is forced high (3V typ.) and the lower driver is turned on as long as the

over-voltage is detected.

7/26

Share Link: