LTC4061 查看數據表（PDF） - Linear Technology
零件编号
产品描述 (功能)
生产厂家
LTC4061 Datasheet PDF : 20 Pages
| |||
Operation
VCC
RNOM
NTC
2
RNTC
0.76 • VCC
–
+
0.35 • VCC
+
–
TOO COLD
TOO HOT
+
0.016 • VCC
–
ENABLE
LTC4061
4061 F01
Figure 1. NTC Circuit Information
LTC4061
Applications Information
Programming Charge Termination
The LTC4061 can terminate a charge cycle using one of
several methods, allowing the designer considerable flex-
ibility in choosing an ideal charge termination algorithm.
Table 1 shows a brief description of the different termination
methods and their behaviors.
Charge Time Termination
Connecting a capacitor (CTIMER) to the TIMER pin enables
the timer and selects charge time termination. The total
charge time is set by:
TIME
(HOURS) =
CTIMER
0.1µF
•3
HOURS
Table 1.
METHOD
Charge
Time
Termination
Mode
Charge
Current
Termination
User
Selectable
Charge
Termination
TIMER
0.1µF to
GND
0.1µF to
GND
GND
GND
VCC
VCC
IDET
RDET to
GND
NC
RDET to
GND
NC
RDET to
GND
NC
CHARGER DESCRIPTION
Charges for 3 Hours. After 3 Hours, the Charger
Stops Charging and Enters Standby Mode.
Recharge Cycles Last for 1.5 Hours.
Charges for 3 Hours. After 3 Hours, the Charger
Stops Charging and Enters Standby Mode.
Recharge Cycles Last for 1.5 Hours.
Charges Until Charge Current Drops Below
IDET, Then Enters Standby Mode.
Charges Indefinitely.
Charges Indefinitely.
SmartStart Is Disabled.
Charges Indefinitely.
SmartStart Is Disabled.
CHRG OUTPUT DESCRIPTION
Pull-Down State While IBAT > IDET. High Impedance
State While IBAT < IDETECT or When Charging Is Stopped.
Pulsing State Available When NTC Is Used and
Is Still Charging.
Pull-Down State When Charging. High Impedance State
When Charging Is Stopped. Pulsing State Available
When NTC Is Used and Is Still Charging.
Pull-Down State When Charging. High Impedance State
When Charging Is Stopped. Pulsing State Available
When NTC Is Used and Is Still Charging.
Pull-Down State When Charging. High Impedance State
When Charging Is Stopped. Pulsing State Available
When NTC Is Used and Is Still Charging.
Pull-Down State While IBAT > IDETECT. High Impedance
State While IBAT < IDETECT or When Charging Is Stopped.
Pulsing State Available When NTC Is Used and
Is Still Charging.
Pull-Down State When Charging. High Impedance State
When Charging Is Stopped. Pulsing State Available
When NTC Is Used and Is Still Charging.
4061fd
11
Share Link: 