MT88E46 查看數據表（PDF） - Zarlink Semiconductor Inc

零件编号

产品描述 (功能)

生产厂家

MT88E46

Bellcore Compliant Calling Number Identification Circuit

Zarlink Semiconductor Inc 

Data Sheet

MT88E46

CPE goes off-hook

CPE mutes handset, disables keypad

and performs MEI check (See TIA/EIA-777)

TIP/RING

PWDN

(Note 6)

Note 1

Off Hook CASen

(Note 6)

CPE sends

CAS

ACK

Mark

Data

A

B

C

D

E

F

25ms

Note 5

30-40ms

FSKen

(Note 6)

OSC2

DET

(Note 7)

CD

Note 2

tPU

tDET2

tDW

Note 3

tCP

DR

(Note 7)

DCLK

DATA

Data

CPE unmutes handset

and enables keypad

Speech

G

Note 4

tCA

A = 75-85ms

B = 0-100ms

C = 55-65ms

D = 0-500ms

E = 58-75ms

F = feature specific

G ≤ 50ms

Figure 17 - Application Timing: Bellcore Off-Hook Data Transmission, e.g. CIDCW

Notes:

1) In a CPE where AC power is not available, the designer may choose to switch over to line power when the CPE goes off-hook and use battery

power while on-hook. The CPE must also be CID (on-hook) capable because a CIDCW CPE includes CID functionality.

2) Non-FSK signals such as CAS, speech and DTMF tones are in the same frequency band as FSK. They will be demodulated and give false data.

Therefore the MT88E46 should be taken out of FSK mode when FSK is not expected.

3) If the CPE is the ACK-Sender, the MT88E46 may be put into FSK mode right after ACK has been sent. If the CPE is not the ACK-Sender, the

MT88E46 should be put into FSK mode at 30 ms (min ACK delay) + 55 ms (min ACK duration) = 85 ms after the line HIGH transition. In that

case the FSK carrier detector may be activated by the ACK if both the ACK delay and the ACK duration are at maximum. TR-NWT-000575

specifies that ACK = DTMF ‘D’ for non-ADSI CPE, ‘A’ for ADSI CPE.

4) The MT88E46 should be taken out of FSK mode when CD has become inactive, or when more than 5 framing errors have been detected in the

message, or when more than 150 ms of continuous Mark or Space has been detected.

5) In an unsuccessful attempt where the central office does not send the FSK signal, the CPE should unmute the handset and enable the keypad

after interval D has expired.

6) PWDN, Off Hook CASen and FSKen are internal signals decoded from CB0/1/2.

7) The DR/DET output pin is the DET signal when CAS detection is selected, the DR signal when FSK is selected.

21

Share Link: