PTN3332 查看數據表（PDF） - Philips Electronics

零件编号

产品描述 (功能)

生产厂家

PTN3332

High speed differential line receiver

Philips Electronics 

Philips Semiconductors

PTN3332

High speed differential line receiver

14. Soldering

9397 750 08341

Product data

14.1 Introduction to soldering surface mount packages

This text gives a very brief insight to a complex technology. A more in-depth account

of soldering ICs can be found in our Data Handbook IC26; Integrated Circuit

Packages (document order number 9398 652 90011).

There is no soldering method that is ideal for all IC packages. Wave soldering can still

be used for certain surface mount ICs, but it is not suitable for fine pitch SMDs. In

these situations reflow soldering is recommended. In these situations reflow

soldering is recommended.

14.2 Reflow soldering

Reflow soldering requires solder paste (a suspension of fine solder particles, flux and

binding agent) to be applied to the printed-circuit board by screen printing, stencilling

or pressure-syringe dispensing before package placement. Driven by legislation and

environmental forces the worldwide use of lead-free solder pastes is increasing.

Several methods exist for reflowing; for example, convection or convection/infrared

heating in a conveyor type oven. Throughput times (preheating, soldering and

cooling) vary between 100 and 200 seconds depending on heating method.

Typical reflow peak temperatures range from 215 to 270 °C depending on solder

paste material. The top-surface temperature of the packages should preferably be

kept:

• below 225 °C (SnPb process) or below 245 °C (Pb-free process)

– for all BGA, HTSSON..T and SSOP..T packages

– for packages with a thickness ≥ 2.5 mm

– for packages with a thickness < 2.5 mm and a volume ≥ 350 mm3 so called

thick/large packages.

• below 240 °C (SnPb process) or below 260 °C (Pb-free process) for packages with

a thickness < 2.5 mm and a volume < 350 mm3 so called small/thin packages.

Moisture sensitivity precautions, as indicated on packing, must be respected at all

times.

14.3 Wave soldering

Conventional single wave soldering is not recommended for surface mount devices

(SMDs) or printed-circuit boards with a high component density, as solder bridging

and non-wetting can present major problems.

To overcome these problems the double-wave soldering method was specifically

developed.

If wave soldering is used the following conditions must be observed for optimal

results:

• Use a double-wave soldering method comprising a turbulent wave with high

upward pressure followed by a smooth laminar wave.

Rev. 01 — 07 January 2004

© Koninklijke Philips Electronics N.V. 2004. All rights reserved.

12 of 16

Share Link: