SAA7374 查看數據表（PDF） - Philips Electronics
零件编号
产品描述 (功能)
生产厂家
SAA7374 Datasheet PDF : 60 Pages
| |||
Philips Semiconductors
Low voltage digital servo processor and
Compact Disc decoder (CD7LV)
Product specification
SAA7374
7.7.3 CONCEALMENT
A 1-sample linear interpolator becomes active if a single
sample is flagged as erroneous but cannot be corrected.
The erroneous sample is replaced by a level midway
between the preceding and following samples. Left and
right channels have independent interpolators. If more
than one consecutive non-correctable sample is found, the
last good sample is held. A 1-sample linear interpolation is
then performed before the next good sample (see Fig.10).
In CD-ROM modes (i.e. the DAC interface is selected to be
in a CD-ROM format) concealment is not executed.
7.7.4 MUTE, FULL-SPEED, ATTENUATION AND FADE
A digital level controller is present on the SAA7374 which
performs the functions of soft mute, full scale, attenuation
and fade; these are selected via register 0.
Mute: signal reduced to 0 in a maximum of 128 steps;
(3/n) µs.
Attenuate: signal scaled by −12 dB.
Full scale: ramp signal back to 0 dB level. From mute
takes (3/n) µs.
Fade: activates a 128 stage counter which allows the
signal to be scaled up/down by 0.07 dB steps
128 = full scale.
120 = −0.5 dB (i.e. full scale if oversampling filter
used).
32 = −12 dB.
0 = mute.
7.7.5 PEAK DETECTOR
The peak detector measures the highest audio level
(absolute value) on positive peaks for left and right
channels. The 8 most significant bits are output in the
Q-channel data in place of the CRC bits. Bits 81 to 88
contain the left peak value (bit 88 = MSB) and
bits 89 to 96 contain the right peak value (bit 96 = MSB).
The values are reset after reading Q-channel data via
SDA.
Interpolation
Hold
Interpolation
OK
Error
OK
Error
Error
Error
OK
OK
MGA372
Fig.10 Concealment mechanism.
1998 Feb 26
15
Share Link: 