DLP0NSA150HL2L 查看數據表（PDF） - Murata Manufacturing
零件编号
产品描述 (功能)
生产厂家
DLP0NSA150HL2L Datasheet PDF : 40 Pages
| |||
PLp Chip Common Mode Choke Coil Soldering and Mounting
3. Standard Soldering Conditions
(1) Soldering Methods
Use reflow soldering methods only.
Use standard soldering conditions when soldering chip
common mode choke coils.
In cases where several different parts are soldered, each
having different soldering conditions, use those
conditions requiring the least heat and minimum time.
Solder: Use Sn-3.0Ag-0.5Cu solder. Use of Sn-Zn based
solder will deteriorate performance of products.
Flux:
o Use Rosin-based flux.
use Rosin-based flux.
o Do not use strong acidic flux (with chlorine content
exceeding 0.20wt%)
o Do not use water-soluble flux.
For additional mounting methods, please contact Murata.
(2) Soldering Profile
oReflow Soldering Profile
(Sn-3.0Ag-0.5Cu Solder)
T4
T2
T3
T1
180
150
Limit Profile
Pre-heating t1
t2
Standard Profile
90s±30s
time (s)
Series
PLT10H
Standard Profile
Heating
Peak
Temperature
Cycle
Temp. (T1) Time. (t1)
(T2)
of Reflow
Limit Profile
Heating
Peak
Temperature
Cycle
Temp. (T3) Time. (t2)
(T4)
of Reflow
220°C min. 30 to 60s 250±3°C
2 times
max.
230°C min. 60s max. 260°C/10s
2 times
max.
(3) Reworking with Solder Iron
The following conditions must be strictly followed when
using a soldering iron.
Pre-heating: 150°C 60s min.
Soldering iron power output / Tip diameter:
80W max. / ø3mm max.
Temperature of soldering iron tip / Soldering time / Times:
400°C max. / 5s / 2 times
Do not allow the tip of the soldering iron to directly
contact the chip.
For additional methods of reworking with a soldering iron,
please contact Murata engineering.
4. Cleaning
Do not clean after soldering. If cleaning, please contact us.
!Note • Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
C31E.pdf
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please review our product specifications or consult the approval sheet for product specifications before ordering.
Mar.28,2011
181
Share Link: 