IMSA110 查看數據表（PDF） - STMicroelectronics

零件编号

产品描述 (功能)

生产厂家

IMSA110

IMAGE AND SIGNAL PROCESSING SUB–SYSTEM

STMicroelectronics 

IMSA110

11. ELECTRICAL SPECIFICATION

11.1 DC electrical characteristics

ABSOLUTE MAXIMUM RATINGS

Symbol

VCC

VI, VO

TA

Tstg

PDmax

Parameter

DC supply voltage

Voltage on any other pin

Temperature under bias

Storage temperature

Power dissipation

Min.

0

-1.0

-40

-65

Typ.

Max.

7.0

VCC+0.5

85

150

2.0

Units

V

V

°C

°C

W

Notes (1,2)

3

3

Notes : 1. All voltages are with respect to GND.

2. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the

operational sections of this specification is not implied. Stresses greater than those listed may cause permanent damage to the

device. Exposure to absolute maximum rating conditions for extended periods may affect reliability.

3. This device contains circuitry to protect the inputs against damage caused by high static voltages or electrical fields. However,

it is advised that normal precautions be taken to avoid application of any voltage higher than the absolute maximum rated

voltages to this high impedence circuit. Unused inputs should be tied to an appropriate logic level such as VCC or GND.

DC OPERATING CONDITIONS

Symbol

VCC

VIH

VIL

TA

Parameter

Supply Voltage

Input Logic ‘1’ Voltage CLK

Input Logic ‘1’ Voltage other pins

Input Logic ‘0’ Voltage CLK

Input Logic ‘0’ Voltage other pins

Ambient Operating Temperature

Min.

4.5

4.0

2.0

-0.5

-0.5

0

Typ.

5.0

Max.

5.5

VCC+0.5

VCC+0.5

0.5

0.8

70

Units

V

V

V

V

V

°C

Notes (1)

2

2

2

2

3

Notes : 1. All voltages are with respect to GND.

2. Input signal transients, up to 10ns wide, are permitted in the voltage ranges (GND - 0.5V) to (GND - 1.0V)

and VCC + 0.5V to VCC + 1.0V.

3. 400 linear ft/min transverse air flow.

DC CHARACTERISTICS

Symbol

Parameter

Min.

VOH

Output Logic ‘1’ Voltage

2.4

VOL

Output Logic ‘0’ Voltage

0

IIN

Input leakage current(any input current)

IOZ

Off state output leakage current

IDD

Average power supply current

Notes : 1. All voltages are with respect to GND.

2. Parameters measured over full voltage and temperature operating range.

3. VCC = VCC(max), GND ≤ VIN ≤ VCC

4. IOut ≤ -4.4 mA

5. IOut ≤ 4.4 mA

CAPACITANCE

Pin

Min.

CLK

All other pins

Notes : 1. This parameter is supplied for engineering guidance and is not guaranteed.

2. TA= 25°C , F= 1 MHz.

Typ.

Typ.

12

5

Max.

VCC

0.4

± 10

± 10

350

Units

V

V

µA

µA

mA

Notes (1,2)

4

5

3

3

Max.

Units

pF

pF

Notes

1,2

1,2

21/26

Share Link: