LM358YD(2007) 查看數據表（PDF） - STMicroelectronics
零件编号
产品描述 (功能)
生产厂家
LM358YD Datasheet PDF : 20 Pages
| |||
Absolute maximum ratings
2
Absolute maximum ratings
LM158-LM258-LM358
Table 1.
Symbol
Absolute maximum ratings
Parameter
LM158,A LM258,A LM358,A Unit
VCC
Vi
Vid
Ptot
Iin
Toper
Tstg
Tj
Rthja
Rthjc
ESD
Supply voltage
+/-16 or 32
Input voltage
32
Differential input voltage
Power dissipation (1)
Output short-circuit duation (2)
Input current (3)
32
500
Infinite
50
Operating free-air temperature range
-55 to +125 -40 to +105 0 to +70
Storage temperature range
-65 to +150
Maximum junction temperature
150
Thermal resistance junction to ambient(4) (5)
SO-8
125
MiniSO-8
190
TSSOP8
120
DIP-8
85
Thermal resistance junction to case
SO-8
40
MiniSO-8
39
TSSOP8
37
DIP-8
41
HBM: human body model(6)
300
MM: machine model(7)
200
CDM: charged device model(8)
1.5
V
V
V
mW
mA
°C
°C
°C
°C/W
°C/W
V
V
kV
1. Power dissipation must be considered to ensure that the maximum junction temperature (Tj) is not
exceeded.
2. Short-circuits from the output to VCC can cause excessive heating if VCC > 15 V. The maximum output
current is approximately 40 mA independent of the magnitude of VCC. Destructive dissipation can result
from simultaneous short-circuits on all amplifiers.
3. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the
collector-base junction of the input PNP transistor becoming forward biased and thereby acting as input
diode clamps. In addition to this diode action, there is also NPN parasitic action on the IC chip. This
transistor action can cause the output voltages of the Op-amps to go to the VCC voltage level (or to ground
for a large overdrive) for the time during which an input is driven negative.
This is not destructive and normal output is restored for input voltages above -0.3 V.
4. Short-circuits can cause excessive heating and destructive dissipation.
5. Rth are typical values.
6. Human body model: A 100pF capacitor is charged to the specified voltage, then discharged through a
1.5kΩ resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
7. Machine model: A 200pF capacitor is charged to the specified voltage, then discharged directly between
two pins of the device with no external series resistor (internal resistor < 5Ω). This is done for all couples of
connected pin combinations while the other pins are floating.
8. Charged device model: all pins and the package are charged together to the specified voltage and then
discharged directly to the ground through only one pin. This is done for all pins.
4/20
Share Link: 