PIC16C925 View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16C925

64/68-Pin CMOS Microcontrollers with LCD Driver

Microchip Technology 

PIC16C925/926

1.1 Clocking Scheme/Instruction

Cycle

The clock input (from OSC1) is internally divided by

four to generate four non-overlapping quadrature

clocks, namely Q1, Q2, Q3 and Q4. Internally, the pro-

gram counter (PC) is incremented every Q1, the

instruction is fetched from the program memory and

latched into the instruction register in Q4. The instruc-

tion is decoded and executed during the following Q1

through Q4. The clocks and instruction execution flow

are shown in Figure 1-2.

1.2 Instruction Flow/Pipelining

An “Instruction Cycle” consists of four Q cycles (Q1,

Q2, Q3 and Q4). The instruction fetch and execute are

pipelined, such that fetch takes one instruction cycle,

while decode and execute takes another instruction

cycle. However, due to the pipelining, each instruction

effectively executes in one cycle. If an instruction

causes the program counter to change (e.g. GOTO),

then two cycles are required to complete the instruction

(Example 1-1).

A fetch cycle begins with the program counter (PC)

incrementing in Q1.

In the execution cycle, the fetched instruction is latched

into the “Instruction Register” in cycle Q1. This instruc-

tion is then decoded and executed during the Q2, Q3,

and Q4 cycles. Data memory is read during Q2 (oper-

and read) and written during Q4 (destination write).

FIGURE 1-2:

CLOCK/INSTRUCTION CYCLE

Q1 Q2 Q3 Q4

OSC1

Q1

Q2

Q3

Q4

PC

PC

OSC2/CLKOUT

(RC mode)

Fetch INST (PC)

Execute INST (PC-1)

Q1 Q2 Q3 Q4

PC+1

Fetch INST (PC+1)

Execute INST (PC)

Q1 Q2 Q3 Q4

PC+2

Fetch INST (PC+2)

Execute INST (PC+1)

Internal

Phase

Clock

EXAMPLE 1-1: INSTRUCTION PIPELINE FLOW

1. MOVLW 55h

TCY0

Fetch 1

TCY1

Execute 1

2. MOVWF PORTB

Fetch 2

3. CALL SUB_1

4. BSF PORTA, BIT3 (Forced NOP)

5. Instruction @ address SUB_1

TCY2

Execute 2

Fetch 3

TCY3

TCY4

TCY5

Execute 3

Fetch 4

Flush

Fetch SUB_1 Execute SUB_1

All instructions are single cycle, except for any program branches. These take two cycles, since the fetch instruction

is “flushed” from the pipeline while the new instruction is being fetched and then executed.

 2001 Microchip Technology Inc.

Preliminary

DS39544A-page 9

Share Link: