ATTINY43U-MUR View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

ATTINY43U-MUR

8-bit Microcontroller with 4K Bytes In-System Programmable Flash and Boost Converter

Atmel Corporation 

The calibrated Oscillator is used to time the EEPROM accesses. Make sure the Oscillator fre-

quency is within the requirements described in “OSCCAL – Oscillator Calibration Register” on

page 28.

The following code examples show one assembly and one C function for erase, write, or atomic

write of the EEPROM. The examples assume that interrupts are controlled (e.g., by disabling

interrupts globally) so that no interrupts will occur during execution of these functions.

Assembly Code Example

EEPROM_write:

; Wait for completion of previous write

sbic EECR,EEPE

rjmp EEPROM_write

; Set Programming mode

ldi r16, (0<<EEPM1)|(0<<EEPM0)

out EECR, r16

; Set up address (r17) in address register

out EEAR, r17

; Write data (r19) to data register

out EEDR,r19

; Write logical one to EEMPE

sbi EECR,EEMPE

; Start eeprom write by setting EEPE

sbi EECR,EEPE

ret

C Code Example

void EEPROM_write(unsigned char ucAddress, unsigned char ucData)

{

/* Wait for completion of previous write */

while(EECR & (1<<EEPE))

;

/* Set Programming mode */

EECR = (0<<EEPM1)|(0<<EEPM0)

/* Set up address and data registers */

EEAR = ucAddress;

EEDR = ucData;

/* Write logical one to EEMPE */

EECR |= (1<<EEMPE);

/* Start eeprom write by setting EEPE */

EECR |= (1<<EEPE);

}

Note: See “Code Examples” on page 6.

18 ATtiny43U

8048C–AVR–02/12

Share Link: