SSD1820A View Datasheet(PDF) - Solomon Systech

Part Name

Description

Manufacturer

SSD1820A

LCD Segment / Common Driver with Controller

Solomon Systech  

HV Buffer Cell (Level Shifter)

HV Buffer Cell works as a level shifter which translates the low

voltage output signal to the required driving voltage. The output is

shifted out with an internal FRM clock which comes from the Display

Timing Generator. The voltage levels are given by the level selector

which is synchronized with the internal M signal.

Reset Circuit

When RES input is low, the chip is initialized to the following:

1. Page address is set to 0

2. Column address is set to 0

3. Display is OFF

4. Display Start Line is set to 0 (GDDRAM page 0, D0)

5. Display Offset is set to 0 (COM0 is mapped to ROW0)

6. 128x64 for SSD1820A / 128x80 for SSD1821

7. Normal/Reverse Display is Normal

8. n-line Inversion Register is 0

9. Entire Display is OFF

10. Power Control Register (VC, VR, VF) is set to (0,0,0)

11. 2X/3X Booster is selected

12. Internal Resistor Ratio register is set to 0H

13. Software Contrast is set to 32

14. LCD Bias Ratio is set to 1/9 for SSD1820A and 1/10 for

SSD1821.

15. Normal scan direction of COM outputs

16. Segment remap is disabled (SEG0 display column address 0)

17. Internal oscillator is OFF

18. Test mode is OFF

19. Temperature coefficient is set to PTC0 for SSD1820A and

PTC1 for SSD1821.

20. Icon display line is OFF

21. Interface Lock / Unlock register will be clear

When RESET command is issued, the following parameters are

initialized only:

1. Page address is set to 0

2. Column address is set to 0

3. Initial Display Line is set to 0 (point to display RAM page 0, D0)

4. Internal Resistor Ratio register is set to 0H

SSD1820A/21 REV 1.4

16

01/03

SOLOMON

Share Link: