SAM4CP16B View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

SAM4CP16B

SMART Power Line Communications Device

Atmel Corporation 

 Ultra low-power RTC with Gregorian and Persian Calendar, waveform generation in low-power modes and

clock calibration circuitry for 32.768 kHz crystal frequency compensation circuitry

 Up to 23 peripheral DMA (PDC) channels

 Shared Peripherals

 One Segmented LCD Controller

 Display Capacity of 46 Segments and 5 Common Terminals

 Software Selectable LCD Output Voltage (Contrast)

 Low Current Consumption in Steady State Mode

 Can be used in Backup mode

 Up to 5 USARTs with ISO7816, IrDA®, RS-485, SPI and Manchester Mode

 Two 2-wire UARTs with one UART (UART1) supporting optical transceiver providing an electrically isolated

serial communication with hand-help equipment, such as calibrators, compliant with ANSI-C12.18 or

IEC62056-21 norms

 Two 400 kHz Master/Slave and Multi-Master Two-wire Interface (I2C compatible)

 One SPI

 Two 3-Channel 16-bit Timer/Counter with capture, waveform, compare and PWM mode. Quadrature

Decoder Logic and 2-bit Gray Up/Down Counter for Stepper Motor

 4-channel 16-bit Pulse Width Modulator

 32-bit Real-time Timer

 PRIME PLC

 Modem

 Power Line Carrier Modem for 50 Hz and 60 Hz mains

 97-carriers OFDM PRIME compliant

 DBPSK, DQPSK, D8PSK modulation schemes available

 Additional enhanced modes available: DBPSK Robust, DQPSK Robust, named “PRIME + Robust” in

this datasheet

 Eight selectable channels between 42kHz to 472kHz available. Only one channel can be active at a

time

 Baud rate Selectable: 5.4 to 128.6 kbps

 Four dedicated buffers for transmission/reception

 Up to 124.6 dBμVrms injected signal against PRIME load

 Up to 79.6 dB of dynamic range in PRIME networks

 Automatic Gain Control and continuous amplitude tracking in signal reception

 Class D switching power amplifier control

 Integrated 1.2V LDO regulator to supply analog functions

 Medium Access Control co-processor features

 Viterbi soft decoding and PRIME CRC calculation

 128-bit AES encryption

 Channel sensing and collision pre-detection

 Analog Conversion Block

 8-channel, 500 kS/s, Low Power, 10-Bit SAR ADC with Digital averager providing 12-bit resolution at 30

kS/s

 Software Controlled On-Chip Reference ranging from 1.6V to 3.4V

 Temperature Sensor and Backup Battery Voltage Measurement Channel

SAM4CP [DATASHEET]

3

43051E–ATPL–08/14

Share Link: