LPC2106BBD48 View Datasheet(PDF) - Philips Electronics

Part Name

Description

Manufacturer

LPC2106BBD48

Single-chip 32-bit microcontrollers; 128 kB ISP/IAP Flash with 64 kB/32 kB/16 kB RAM

Philips Electronics 

Philips Semiconductors

LPC2104/2105/2106

Single-chip 32-bit microcontrollers

6.12 SPI serial I/O controller

The SPI is a full duplex serial interface, designed to be able to handle multiple

masters and slaves connected to a given bus. Only a single master and a single slave

can communicate on the interface during a given data transfer. During a data transfer

the master always sends a byte of data to the slave, and the slave always sends a

byte of data to the master.

6.12.1 Features

• Compliant with Serial Peripheral Interface (SPI) specification.

• Synchronous, Serial, Full Duplex, Communication.

• Combined SPI master and slave.

• Maximum data bit rate of one eighth of the input clock rate.

6.13 General purpose timers

The Timer is designed to count cycles of the peripheral clock (PCLK) and optionally

generate interrupts or perform other actions at specified timer values, based on four

match registers. It also includes four capture inputs to trap the timer value when an

input signal transitions, optionally generating an interrupt.

6.13.1 Features

• A 32-bit Timer/Counter with a programmable 32-bit Prescaler.

• Up to four (TImer 1) and three (Timer 0) 32-bit capture channels, that can take a

snapshot of the timer value when an input signal transitions. A capture event may

also optionally generate an interrupt.

• Four 32-bit match registers that allow:

– Continuous operation with optional interrupt generation on match.

– Stop timer on match with optional interrupt generation.

– Reset timer on match with optional interrupt generation.

• Up to four (Timer 1) and three (Timer 0) external outputs corresponding to match

registers, with the following capabilities:

– Set LOW on match.

– Set HIGH on match.

– Toggle on match.

– Do nothing on match.

6.14 Watchdog timer

The purpose of the Watchdog is to reset the microcontroller within a reasonable

amount of time if it enters an erroneous state. When enabled, the Watchdog will

generate a system reset if the user program fails to ‘feed’ (or reload) the Watchdog

within a predetermined amount of time.

9397 750 12792

Product data

Rev. 04 — 05 February 2004

© Koninklijke Philips Electronics N.V. 2004. All rights reserved.

17 of 32

Share Link: