LPC2109 View Datasheet(PDF) - NXP Semiconductors.

Part Name

Description

Manufacturer

LPC2109

Single-chip 16/32-bit microcontrollers; 64/128/256 kB ISP/IAP flash with 10-bit ADC and CAN

NXP Semiconductors. 

NXP Semiconductors

LPC2109/2119/2129

Single-chip 16/32-bit microcontrollers

6.12 SPI serial I/O controller

The LPC2109/2119/2129 each contain two SPIs. The SPI is a full duplex serial interface,

designed to be able to handle multiple masters and slaves connected to a given bus. Only

a single master and a single slave can communicate on the interface during a given data

transfer. During a data transfer the master always sends a byte of data to the slave, and

the slave always sends a byte of data to the master.

6.12.1 Features

• Compliant with Serial Peripheral Interface (SPI) specification.

• Synchronous, Serial, Full Duplex communication.

• Combined SPI master and slave.

• Maximum data bit rate of 1⁄8 of the input clock rate.

6.12.2 Features available in LPC2109/2119/2129/01 only

• Eight to 16 bits per frame.

• When the SPI interface is used in Master mode, the SSELn pin is not needed (can be

used for a different function).

6.13 SSP controller (LPC2109/2119/2129/01 only)

Remark: This peripheral is available in LPC2109/2119/2129/01 only.

The SSP is a controller capable of operation on a SPI, 4-wire SSI, or Microwire bus. It can

interact with multiple masters and slaves on the bus. Only a single master and a single

slave can communicate on the bus during a given data transfer. Data transfers are in

principle full duplex, with frames of four to 16 bits of data flowing from the master to the

slave and from the slave to the master.

While the SSP and SPI1 peripherals share the same physical pins, it is not possible to

have both of these two peripherals active at the same time. Application can switch on the

fly from SPI1 to SSP and back.

6.13.1 Features

• Compatible with Motorola’s SPI, Texas Instrument’s 4-wire SSI, and National

Semiconductor’s Microwire buses.

• Synchronous serial communication.

• Master or slave operation.

• 8-frame FIFOs for both transmit and receive.

• Four to 16 bits per frame.

6.14 General purpose timers

The Timer/Counter is designed to count cycles of the peripheral clock (PCLK) or an

externally supplied clock and optionally generate interrupts or perform other actions at

specified timer values, based on four match registers. It also includes four capture inputs

LPC2109_2119_2129_6

Product data sheet

Rev. 06 — 10 December 2007

© NXP B.V. 2007. All rights reserved.

17 of 44

Share Link: