MACH211SP-10 View Datasheet(PDF) - Unspecified
Part Name
Description
Manufacturer
MACH211SP-10 Datasheet PDF : 33 Pages
| |||
VANTIS
SWITCHING CHARACTERISTICS over COMMERCIAL operating ranges (Note 2)
Parameter
Symbol
Parameter Description
-7
-10
-12
-15
Min Max Min Max Min Max Min Max Unit
tIGOL
Input Latch Gate to Output Through Transparent
Output Latch
14
16
19
22 ns
Setup Time from Input, I/O, or Feedback
tSLL Through Transparent Input Latch to Output Latch 7.5
8.5
9
12
ns
Gate
tIGS
tWIGL
tPDLL
Input Latch Gate to Output Latch Setup
Input Latch Gate Width LOW
Input, I/O, or Feedback to Output Through
Transparent Input and Output Latches
10
11
13
16
ns
3
5
6
6
ns
12.5
14
16
19 ns
Asynchronous Reset to Registered or Latched
tAR
Output
9.5
15
16
20 ns
tARW Asynchronous Reset Width (Note 1)
tARR Asynchronous Reset Recovery Time (Note 1)
Asynchronous Preset to Registered or Latched
tAP
Output
5
10
12
15
ns
5
10
8
10
ns
9.5
15
16
20 ns
tAPW
tAPR
tEA
Asynchronous Preset Width (Note 1)
Asynchronous Preset Recovery Time (Note 1)
Input, I/O, or Feedback to Output Enable
(Note 1)
5
10
12
15
ns
5
10
8
10
ns
9.5
12
15
15 ns
Input, I/O, or Feedback to Output Disable
tER
(Note 1)
9.5
12
15
15 ns
tLP
tPD Increase for Powered-down Macrocell
(Note 3)
10
10
10
10 ns
tLPS tS Increase for Powered-down Macrocell (Note 3)
10
10
10
tLPCO
tCO Increase for Powered-down Macrocell
(Note 3)
0
0
0
10 ns
0
ns
tLPEA
tEA Increase for Powered-down Macrocell
(Note 3)
10
10
10
10 ns
Notes:
1. These parameters are not 100% tested, but are evaluated at initial characterization and at any time the design is modified where
frequency may be affected.
2. See Switching Test Circuit for test conditions.
3. If a signal is powered-down, this parameter must be added to its respective high-speed parameter.
14
MACH211SP-7/10/12/15 (Com’l)
Share Link: 