DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

N4375B View Datasheet(PDF) - HP => Agilent Technologies

Part Name
Description
Manufacturer
N4375B Datasheet PDF : 20 Pages
1 2 3 4 5 6 7 8 9 10 Next Last
Measurement capabilities
3dB cut-off frequency (S21),
Responsivity (S21),
Electrical reflection (S11 or S22),
Group Delay vs. frequency,
Insertion Loss (IL),
Transmission bandwidth,
all electrical S-parameter measurements.
Target test devices
Transmitter (E/O)
‡ 0DFK=HKQGHUPRGXODWRUV
‡ (OHFWURDEVRUSWLRQPRGXODWRUV ($0
‡ 'LUHFWO\PRGXODWHGODVHUV
‡ 7UDQVPLWWHURSWLFDOVXEDVVHPEOLHV 726$
Receiver (O/E)
‡ PIN diodes
‡ Avalanche photodiodes (APD)
‡ Receiver optical subassemblies (ROSA)
Optical (O/O)
‡ Passive optical components
‡ Optical fibers and filters
‡ Optical transmission systems
Agilent N4375B Specifications
Measurement conditions
‡ Modulation frequency range from 10 MHz to 20.0 GHz
‡ Foreward RF power +5 dBm,
option -312, -314, -392, -394
‡ Foreward RF power +3 dBm, option -322, -382
‡ Reverse RF power 0 dBm
‡ Number of averages: 1
‡ 100 Hz IFBW (“Reduce IF bandwidth at low frequency”
enabled) with modulation frequency step size 10 MHz
and measurement points on a 10 MHz raster (if not
differently stated)
‡ Network analyzer set to “stepped sweep – sweep
moves in discrete steps”
‡ All network-analyzer ports configured in standard
coupler configuration (“CPLR ARM” to “RCVB B in”,
“SOURCE OUT” to “CPLR THRU”)
‡ After full two-port electrical calibration using an
Electronic Calibration Module, Agilent N4691B, at
constant temperature (±1° C)
‡ Modulator bias optimization set to “every sweep”
‡ Measurement frequency grid equals electrical
calibration grid
‡ DUT signal delay ≤ 0.1/IF-BW
‡ Specified temperature range: +20° C to +26° C.
‡ After warm-up time of 90 minutes
‡ Using high quality electrical and optical connectors
and RF cables in perfect condition
‡ Using internal laser source
6

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]