ADVANCED COMMUNICATIONS & SENSING
Frf , ook, tx = 9 Flo − Fdev
8
Frf , ook,tx = 9 Fxtal [75(P + 1) + S )] − Fdev
8 R +1
SX1211
Consequently, in receive mode, due to the low intermediate frequency (Low-IF) architecture of the SX1211 the
frequency should be configured so as to ensure the correct low-IF receiver baseband center frequency, IF2.
Frf , ook, rx = 9 Flo − IF 2
8
Frf , ook, rx = 9 Fxtal [75(P + 1) + S )]− IF 2
8 R +1
Note that from Section 3.4.4, it is recommended that IF2 be set to 100 kHz.
Rev 7 – Sept 2nd, 2008
Page 17 of 92
www.semtech.com