µPD784935A,784936A,784937A,784938A
The subsystem oscillator has a low amplification factor so as to lower the current consumption and is more
susceptible to noise than the main system clock oscillator. When using the subsystem clock circuit, therefore, utmost
care must be exercised in wiring the circuit.
If the oscillator does not operate correctly, the microcontroller cannot operate correctly, either. Consult the oscillator
manufacturer if you need an oscillation frequency at high accuracy.
Figure 8-4. Notes on Connecting Resonator
µPD784938A
X2
X1
VSS
Cautions 1. Keep the oscillator as close to the X1 and X2 (XT1 and XT2) pins as possible.
2. Do not pass any other signal lines through the region indicated by the dotted line.
38
Data Sheet U13572EJ2V0DS